Dip switch - Import export

Situations often occur in practice in which it is necessary to place a measuring amplifier immediately in the neighborhood of the sensor in order to be able to access a standard signal there. In this way, long distances to the evaluating electronics can be covered. This task can ideally be performed by the 9236 in-line measuring amplifier. With its high degree of protection (IP67) its singlechannel version can be integrated into the application even in the tough environment outside the switch gear cabinet. — Automatic production machinery — Laboratory measurements — Integration into customer‘s circuit boards — Field measurements Features: — Operates with up to 4 measuring channels — Voltage output 0 to ± 5 V / 0 to ±10 V — Protected against reverse connection and short-circuit — Also available as circuit board without housing — Simple configuration using DIP switch — High degree of protection up to IP67

The transducer unit µCAN.8.ti-SNAP is equipped with 8 inputs for thermocouples or Pt100 sensors. The integrated CAN interface supports CANopen and J1939 protocols. Bit rate and node-ID may be set via DIP switches inside the device or via LSS.

The µCAN.8.dio-SNAP is a freely configurable digital I/O module featuring 8 channels. Module ID and bit rate can be set via DIP switch or via CAN bus (LSS, CiA 305). The module supports the protocols CANopen CANopenFD and J1939.

The DKP900 is a differential pressure transducer suitable for almost every HVAC application. The measurement range as well as the analog output signal can be set and adjusted on site. Therefore you will only have to keep one model type in storage for any of your applications. You can choose from two sensor ranges 0...1 000 Pa and 0...10 000Pa which are scaleable with a DIP switch. The transducer comprises a sensor with good long-term stability and an optional zero point calibration, which can be performed at the push of a button. A module for automated calibration can be built-in, too. This allows for regular calibration and makes it virtually maintenance free. The DKP900 is protected against splash water according to IP65 making it suitable for operation under rough conditions.

This pressure transmitter is particularly well suited for monitoring filters and pressures in HVAC (heating, ventilation and air conditioning) applications. DIP switches allow users to configure the output signal and switchable measurement ranges (optional). Settings provide an option for conversion to a root-extracted output signal (displayed as a % of the maximum output value). An internal button is also available for performing a zero-point correction or fine-tuning the end value. An optional display allows users to read the measured value directly on site in Pa or kPa. With an optional time constant (up to 10s), the instrument can produce an attenuated output signal, even under unstable pressure conditions. An optional two-wire version of the device is also available for reducing wiring complexity. In addition to simple wall-mounting with just 2 screws, the PS 17 is also suitable for mounting on top-hat rails.