Heat generators - Import export

Industrial heating with hot air generators with pellet operation from 43 to 300 kW The hot air generators with pellet operation are fully automatic equipment used for heating industrial, agricultural and livestock premises. Its use is increasingly frequent thanks to its rapid depreciation and neutral CO2 emissions that contribute to the preservation of the environment. The equipment has a basic equipment designed for the use of granulated fuels, an automatic burner that allows the use of granulated fuel such as pellets, olive bone or almond shells. It also has an automatic ash extraction system to keep the combustion chamber in perfect condition and a smoke extractor to ensure proper depression in the combustion chamber. The equipment can be supplied with a fuel tank of 190 or 400 liters capacity with the possibility of applying larger storage systems such as canvas or work silos. The diffusion of the air can be with rotating nozzles or through air ducts.

The electric heating with infrared radiant panels of wave laga are a clean solution, without noise, without emission of light, economic and very comfortable to use n its design and manufacture, the utmost attention has been paid to obtain an aesthetic and effective equipment. The heat radiated from the panel surface is absorbed by people, walls, floors and furniture. Infrared heating does not cause air movement, which will make the air clean and no noise is emitted. Its high heat generation and excellent distribution allow the equipment to be used with less energy than other traditional heating methods. Radiant heat is very good for people′s health, it can change the body′s microcirculation, the cellular organization under the skin produces resonance, cleanses the microcirculation barrier, adjusts and balances the nervous system, promotes metabolism and increases physical power of the body.

Outdoor hot air generator for the heating of tents, covered swimming pools, etc. POOL MANN hot air generators are a perfect solution for the heating of closed premises where a heating system is required where the heat generating equipment must be located outside the room to be heated. Its operation can be diesel, methane gas or propane gas and its operation is based on heating the air drawn in by the fans and driving the hot air inside the room to be heated. The main advantages over other heating systems are: - Reduction of acquisition and installation costs. - Very fast heating system. - Air diffusion can be direct or a network of ducts can be applied to channel the air into adjacent areas where the equipment has been installed. - 90% combustion efficiency.

Industrial warm air heater with diesel or gas operation from 26 to 500 kW The MM hot air generators are indirect heating type equipment (the hot air does not mix with the combustion gases) and they work completely autonomously. They do not need additional elements for heat dissipation, a fact that reduces acquisition, installation and maintenance costs. Its operation is based on the heating of a certain air flow, through the combustion of diesel, natural gas or propane gas. Said flow is aspirated and driven by the fans that the equipment incorporates and that comply with the ERP 2020 regulations. The main advantages over other heating systems are: - Reduction of acquisition and installation costs - Very fast heating system - Air diffusion can be direct or a duct network can be applied - 90% combustion efficiency

These units have been especially designed to make glass beads (by Lithium Borates) for XRF and to undertake dissolutions (using acids) for AA and ICP. This is a modular unit. You can start with a single working unit and then always be able to increase the capacity of the same adding up to two more working units, all controlled from a single PC. Being highly automated units, it is possible to control and monitor in real time each step of the fusion process, from one to three samples, simultaneously or independently. The FX Series is one step ahead of the units of its generation, as it heats homogeneously, quickly and efficiently, by electrical induction, without flame and not needing any direct contact. Each of the modules can work synchronized with the others or independently with a different program each, for example when preparing samples of different nature.