Forcing - Import export

Application: Assays Product group: Albumins : Proteins CAS-Nr.: [9048-46-8] Storing temperature: 2-8°C GHS pictogram: GHS07 EINECS: 232-936-2 Purity: >98.0% Shipping condition: ambient Synonym: Fraction V Appearance: white to yellowish flakes MW: 66.5 kDa UNSPSC-No: 41116134 Formula: 583 amino acids

Product group: Reagents Storing temperature: -20°C Shipping condition: ambient MW: 199.25g/mol Formula: C10H17NO3

Application: Staining and Labelling CAS-Nr.: [23491-52-3] Storing temperature: -20°C GHS signal word: Danger GHS pictogram: GHS05 EINECS: 245-691-1 Purity: >98.0% Appearance: yellow to dark yellow powder MW: 615.98g/mol Formula: C27H28N6O3HCl3H2O

Product group: ReagentsCellular Assays/ Detection-Labeling- kits CAS-Nr.: [194041-65-1] Storing temperature: -20°C MW: 443.43g/mol Formula: C14H18N3NaO8S2

The peel force is a critical parameter for every user of Tape & Reel. If the peel force is too low, the cover tape will not stick on the carrier tape properly and the components may fall out of the pockets. A too high peel force will cause costly down times at the pick & place machines. The KT 5000 peel force tester from KTECH is the ideal tool to measure the peel force on your production floor. For measuring, a strip of the carrier tape is loaded into the KT 5000 and the cover tape is attached to the sensor. The constant movement of the carrier tape is done with a sprocket wheel. The movement speed is controlled with an encoder. The design of the KT 5000 guarantees the same peel angle and the same peel point during the whole measurement. Before each run, the KT 5000 is doing a selfcalibration of the sensor. The measured values are transferred to a PC via a serial RS232 interface. A green bar on the screen shows a good result, if the measurement is out of limit, the bar is red.

This forced ventilation series offers a wide voltage range of 400 to 575 Volt three-phase in IP 66 Made in Europe. Forced vent. - Motor optionally available in three versions. Mb 1F for standard forced ventilation with drive motor in aluminium, in IP66, insul. Class F. Mb 1G for all special versions, drive motor in cast iron, IP66. Special versions further available in insul. Class H, IP67, special voltage etc. Mb 1H with UL/CSA certified drive motor in aluminium, IP66, insul. Class F.

Forced Ventilation Units Forced Ventilation Units type MW in IP 66 with axial ventilation fan to ensure a low run at a simultaneously higher output. These units can be operated at a higher ambient temperature of max. 60 °C.

This forced ventilation series offers a wide voltage range of 220 to 275 (+-5%) Volt single-phase respectively 380 to 480 (+-5%)Volt three-phase in protection class IP 66 The very high stiffness and stability in connection with our flexible assembly possibilities for the extensions and the wide electric field of application offers you a cost-effective, technically high-quality solution for your motors .