Results for
IDG-DICHTUNGSTECHNIK GMBH
Germany
Pivot pins are found on shutoff devices such as spherical valves, butterfly valves, hollow jet valves and plunger valves. These valves are generally used for opening and closing and occasionally to control the flow rates by oscillating movement. The greaselubricated sliding bearing is protected against water infiltration by a seal on the inside. The seal also prevents the grease leaking into the inside to prevent water contamination. The MANOY® system seal WP, type 418, was developed for this application. To prevent leakage of grease from greased bearings, the unidirectional MANOY® system seal WP, type 456, is also installed.
Request for a quoteFEINMETALL GMBH
Germany
Large variety of contact probes (pogo pins) for contacting PCBs even at difficult contacting conditions, different sizes, tip styles and spring forces available.
Request for a quoteWALTER WURSTER GMBH
Germany
Combined pass-through with integrated two-way intercom system. Use in petrol station forecourts as late-night counter, gatehouses and kiosks. Upper small drawer with coin tray for quick removal of cash and passing through receipts, lower drawer for passing through objects up to 170 mm high, such as 5-liter petrol canisters. Third drawer for passing through PIN pad reader.
Request for a quoteECKARDT SYSTEMS GMBH
Germany
Spit nozzle SD 17: version for pin-point and linear application The pneumatically operated SD 17 is also available as a spit nozzle version. The fully spray valve has been specifically developed for pin point and linear application of oils, release agents and other low-viscosity media; it maintains its precision at certain distances between the nozzle and the application object. The spit nozzle SD 17 is particularly suitable for precision lubrication tasks of components and tools; it can also be setup for higher viscosities via an optionally selectable heating unit.
Request for a quoteDo you sell or make similar products?
Sign up to europages and have your products listed
RATEC GMBH
Germany
— Magnetic rubber or neodymium magnets — Temperature exposure up to 60 °C, on request up to 80 °C — Can be delivered with or without chamfer — Partially available with and without groove — The adhesion side is polished — The open design is also available with aluminium caps screwed to the front — The magnet is released with a separate lifting tool
Request for a quoteARNOLD UMFORMTECHNIK GMBH & CO. KG
Germany
TriPress® is a triangular rapid fastening system that can be clinched into plastic and light metals. During the clinching operation, the two components of the TriPress® fastener connect together quickly and economically. It is available in the following designs: Triangular shank and knurl parallel with axis provide greater torsional strength. Circumferential locking flutes on triangular shaft generate high pull-out resistance. Combination of grooves and knurls permit positive-fit fastenings and achieve high torsional torques and pull-out forces (figure 4). So the fastener can be clinched into pre-prepared holes or injected as inserts into plastic housings.
Request for a quoteResults for
Pins - Import exportNumber of results
8 ProductsCompany type