Pins - Import export

Spare pins for tacking guns

Pivot pins are found on shutoff devices such as spherical valves, butterfly valves, hollow jet valves and plunger valves. These valves are generally used for opening and closing and occasionally to control the flow rates by oscillating movement. The greaselubricated sliding bearing is protected against water infiltration by a seal on the inside. The seal also prevents the grease leaking into the inside to prevent water contamination. The MANOY® system seal WP, type 418, was developed for this application. To prevent leakage of grease from greased bearings, the unidirectional MANOY® system seal WP, type 456, is also installed.

Large variety of contact probes (pogo pins) for contacting PCBs even at difficult contacting conditions, different sizes, tip styles and spring forces available.

The press-fit connection provides an enduring mechanical and electrical connection between the printed circuit board and plug connectors. The Compliant Pin has many applications and our customers use them in a wide variety of products, including sensor and radar casings, electronic controllers, plug connectors, printed circuit board connectors and more. Advantages: — no complex soldering process — high mechanical stability — repairable — gas-tight connection at the point of contact

— Magnetic rubber or neodymium magnets — Temperature exposure up to 60 °C, on request up to 80 °C — Can be delivered with or without chamfer — Partially available with and without groove — The adhesion side is polished — The open design is also available with aluminium caps screwed to the front — The magnet is released with a separate lifting tool

TriPress® is a triangular rapid fastening system that can be clinched into plastic and light metals. During the clinching operation, the two components of the TriPress® fastener connect together quickly and economically. It is available in the following designs: Triangular shank and knurl parallel with axis provide greater torsional strength. Circumferential locking flutes on triangular shaft generate high pull-out resistance. Combination of grooves and knurls permit positive-fit fastenings and achieve high torsional torques and pull-out forces (figure 4). So the fastener can be clinched into pre-prepared holes or injected as inserts into plastic housings.