Oil seal rings - Import export

0-29 in HgV (to 33 mbar abs) If you thought you couldn't afford the water costs associated with operating a liquid ring pump…think again. One of the wonderful features of the liquid ring pump is that it can be operated with a multitude of different fluids. A self-contained oil sealed system has a number of benefits over a traditional water sealed system: It eliminates water usage and disposal costs; it allows you to install it in remote locations where water may not be available; it allows you to attain higher vacuum levels than with water; it can prevent the condensing or dissolving of a process gas; it permits anhydrous processing with a liquid ring pump. Self contained system complete with off of the components for your basic operating needs. Standard components include: pump, TEFC motor, coupling or v-belt drive, drive guard, separator with oil mist eliminator, air cooled heat exchanger, recirculated seal line controls and high temperature alarm switch. Options include: inlet isolation valve, inlet check valve, vacuum relief valve, inlet filter, control panel and system skid plate. An oil sealed liquid ring system is more tolerant of carryover and wear, and it provides quiet operation. The oil is not required for lubrication which means it can operate at extremely long intervals between oil changes, easily going more than 10,000 hours with no down time. Aside from a periodic oil and filter change, the system can run for years with no scheduled maintenance. If your process requires very deep vacuum, Gardner Denver Nash has the solution. Using a two-stage liquid ring pump in an oil sealed system, vacuum levels lower than 10 Torr (29.6" HgV) can be attained.

Spherical valves are installed upstream of the turbine as shutoff devices specifically for high pressures at the end of the penstock. Their main function is to close off the penstock during normal shutdown or load shedding of the turbine. The seal is a metal sliding ring which is generally moved by water hydraulics. The MANOY® system seal WP, type 434 (outer sealing) and the inner sealing type 439, were developed for sealing of the sliding ring. The profile dimensions can be customized for maintenance or specific requirements.

Hydraulic and pneumatic cylinders, Presses, Shock absorbers, Fittings, Controls, Piston and plunger pumps, Mobile hydraulics, Injection units

Face seal used for rotary and oscillating motion in pipe joints and rotary actuators. Used at low to high pressure and low speed

ORing in material NBR, FKM, FFKM, VMQ, EPDM, ect.

The X‑ring is a continuous, seamless vulcanized ring with a special profile which is derived from four O‑rings arranged in a square crosssection.The particular advantage of the X‑ring is that it cannot roll or twist. The squeeze required to maintain an effective seal is also relatively low.The X‑ring is used in mechanical and automotive engineering, preferably as a static radial or static axial seal. Other applications are for linear or rotary motion of plungers, pistons, tappets, dampers and valve, bearing and piston rods, etc.