Thinning - Import export

Knurled Nuts Low Type (ECR Low Knurled) Stainless Steel A1 - DIN 467

Low Hexagonal Blind Nuts ((ECR Low Hexagonal Blind) Inox A2 - DIN 917

Bottom Hexagonal Nuts Thread Left (Hm left) Stainless Steel A2 - DIN 439

Low Hexagonal Nuts (ECR Hm Low H50) A4 stainless steel - DIN 439 There is a variant in A2 stainless steel

Low Hexagonal Nuts (ECR Hm Low H50) A2 stainless steel - DIN 439 There is a variant in A4 stainless steel

HEXAGONAL LOW NUTS - METRIC FINE PITCH THREAD Stainless steel A4 - DIN 439 There is a variant in Stainless steel A2

HEXAGONAL LOW NUTS - METRIC FINE PITCH THREAD A2 stainless steel - DIN 439 There is a variant in A4 stainless steel

When screwing the nuts onto the thread, the thread lock is plastically and elastically deformed. The elastic deformation causes a radial frictional lock against the nuts being loosened. The plastic thread lock is only effective when the nuts are fully screwed onto the male thread. The screw length must be selected so that at least two full threads protrude from the nut. Due to the plastic deformation of the thread lock, these nuts should only be used once.

Particularly compact selfcentring keyless locking coupling without axial offset. for shaft diameters from 8 to 85 mm for medium torques suitable for hubs with low wall thickness no axial offset selfcentring Assembly Lightly oil keyless locking coupling on the tapered faces and contact points of the shaft and hub. Do not use MoS2 or grease. Insert keyless locking coupling in the hub seat and slide onto shaft. Tighten screws crosswise in several increments to the defined tightening torque. Dismantling Remove all screws and screw into the extraction threads of the front flange. Tighten screws crosswise in several steps until the keyless locking coupling loosens. Tolerances Shaft Recommended tolerance h8. Surface quality Rz ≤ 16 µm. Hub Recommended tolerance H8. Surface quality Rz ≤ 16 µm.