• europages
  • >
  • COMPANIES - SUPPLIERS - SERVICE PROVIDERS
  • >
  • stainless steel centre

Results for

Stainless steel centre - Import export

FranceDistributor

France

Verified by Europages

Workpieces are clamped and released by compressed air. The possible clamping diameter is from 16 to 20 mm. Material: Body, stainless steel. Seal, NBR. Version: Stainless steel bright. Note for ordering: Cylinder head screws M4X35 for fastening from below are included with delivery. Cylinder head screws with low head M5 for fastening from above are not included with delivery. Note: Installed dimensions for plate thickness 6 mm. The stated retaining forces are related to an operating pressure of 0.5 Mpa and a surface quality of Ra 1.6 µm. Repeat accuracy in this case is ±0.2 mm.

Request for a quote

France

Vertical cylindrical on feet Eccentric conical dome Conical bottom slope 38 % Interior and exterior finish glazed 2B Decentered chimney Ø 400 mm and height 300 mm ELICA 316L stainless steel antiretention hatch 3 simple male DIN 80 fittings on the dome Double acting ELICA 1000 HL stainless steel 316L valve, horn mounting 5 lifting rings including 1 at the bottom of the tank Support + manufacturer's plate 1 single male DIN 65 fitting in ferrule 1 single male DIN 65 fitting in ferrule Taken from the ground 5 thermal regulation rings with water I / O sleeve 4.75 m2 5 heating rings with water I / O sleeve 4.75 m2 Total thermoregulation area 9.5 m2> Thermoregulation ratio per 100 HL 6.31 m2 Tapered connection + stainless steel faceplate for agitator mounting Full stainless steel buffer + EPDM seal for stirring nozzle stirring Total drain pipe + male at the end of DIN 65 piping 4 outside legs, tank height 800 mm Stainless steel flat reinforcement belt 150 x 5

Request for a quote

France

TECHNICAL SPECIFICATIONS - Closed tank 29 500 L D.2800 Automatic punching down - Speidel Type and Ref : FDMTTK280F29500 - Automatic decanter with external cylinder, Döme - Reinforced, 316 L stainless steel, 304 stainless steel shell and base - Off-centre upper hatch D. 400 mm - Decanting door 530 x 400 mm - Height under door approx. 580 mm - Tasting tap DIN 20 - Tapping for temperature measurement with - Needle thermometer and gang finger - Stainless steel ladder support, stainless steel lifting rings - External finish: corked - 3D "mirror-polished" interior finish - Tapping system : - 220 V/50 Hz electronic control - Stainless steel tapping arm - 6 bar working pressure, dry air - Pneumatic cylinder flanged to the dome

Request for a quote

Do you sell or make similar products?

Sign up to europages and have your products listed

Add my business