Stainless steel centre - Import export

Workpieces are clamped and released by compressed air. The possible clamping diameter is from 16 to 20 mm. Material: Body, stainless steel. Seal, NBR. Version: Stainless steel bright. Note for ordering: Cylinder head screws M4X35 for fastening from below are included with delivery. Cylinder head screws with low head M5 for fastening from above are not included with delivery. Note: Installed dimensions for plate thickness 6 mm. The stated retaining forces are related to an operating pressure of 0.5 Mpa and a surface quality of Ra 1.6 µm. Repeat accuracy in this case is ±0.2 mm.

Vertical cylindrical on feet Eccentric conical dome Conical bottom slope 38 % Interior and exterior finish glazed 2B Decentered chimney Ø 400 mm and height 300 mm ELICA 316L stainless steel antiretention hatch 3 simple male DIN 80 fittings on the dome Double acting ELICA 1000 HL stainless steel 316L valve, horn mounting 5 lifting rings including 1 at the bottom of the tank Support + manufacturer's plate 1 single male DIN 65 fitting in ferrule 1 single male DIN 65 fitting in ferrule Taken from the ground 5 thermal regulation rings with water I / O sleeve 4.75 m2 5 heating rings with water I / O sleeve 4.75 m2 Total thermoregulation area 9.5 m2> Thermoregulation ratio per 100 HL 6.31 m2 Tapered connection + stainless steel faceplate for agitator mounting Full stainless steel buffer + EPDM seal for stirring nozzle stirring Total drain pipe + male at the end of DIN 65 piping 4 outside legs, tank height 800 mm Stainless steel flat reinforcement belt 150 x 5

TECHNICAL SPECIFICATIONS - Closed tank 29 500 L D.2800 Automatic punching down - Speidel Type and Ref : FDMTTK280F29500 - Automatic decanter with external cylinder, Döme - Reinforced, 316 L stainless steel, 304 stainless steel shell and base - Off-centre upper hatch D. 400 mm - Decanting door 530 x 400 mm - Height under door approx. 580 mm - Tasting tap DIN 20 - Tapping for temperature measurement with - Needle thermometer and gang finger - Stainless steel ladder support, stainless steel lifting rings - External finish: corked - 3D "mirror-polished" interior finish - Tapping system : - 220 V/50 Hz electronic control - Stainless steel tapping arm - 6 bar working pressure, dry air - Pneumatic cylinder flanged to the dome

Alloy 17-4 PH is a chromium-copper precipitation hardening martensitic stainless steel with Cu and Nb/Cb additions. 17-4PH Stainless Steel combines high strength, hardness (up to 572°F / 300°C), and moderate corrosion resistance. Alloy 17-4 PH withstands corrosive attacks better than any of the standard hardenable stainless steels and is comparable to Alloy 304 in most media. The alloy is subject to crevice or pitting attack if exposed to stagnant seawater for any length of time, although it is corrosion resistant in some chemical, petroleum, paper, dairy and food processing industries(equivalent to 304L grade). Mechanical properties can be improved (high strength and superior corrosion resistance) when precipitation hardened from Condition A to one of the Condition H tempers. We supply 17-4 PH in the H1150D condition. This is double aged at a temperature between 1140° F and 1160° F for 3.75 hours to 4.

Stainless Steel Strips in grades 430, 304, 316.

Stainless steel Flange