Flange gaskets - Import export

FLANGE Ø180 WITH 8 THREADED HOLES FLANGE Ø247 WITH 12 HOLES FLANGE Ø300 WITH 12 HOLES FLANGE Ø300 WITH 16 HOLES FLANGE Ø380 WITH 19 HOLES FLANGE Ø430 WITH 22 HOLES

The DATL/DAT dampers are designed for cladding with up to 50 mm thick insulation. The DATL/DAT dampers are a good choice when the ductwork closure must be airtight. The damper closure position can be read on the 0° to 90° dial of the control handle. The damper closure opening ratio can be fixed with a screw. DAT — airtight shutoff damper DATL — airtight shutoff damper with gaskets at flanged ends All DATL/DAT dampers of diameter 355 mm or greater have the damper closure pivot provided with extra bracing. All DATL/DAT dampers of diameter 450 mm or greater are supplied with the KITDSH damper mechanism control lever. Standard dampers are made from galvanized steel sheet.

The SLEFL flexible silencer is made of the Alnor Flex perforated duct. The sound insulating layer is 25 mm thick and clad in aluminium and polyester. The silencer is connected to the ductwork with male flanges made of metal. The product is available in two length sizes, 600 mm and 1200 mm. Other silencer versions are available on request with EPDM gaskets, female flanges, or in other length sizes. Insulation Insulation material glass wool. Insulation type trimmed from reel, flexible. Temperature range 20°C to +140°C Thermal insulation performance of mineral wool λ = 0.034 W/mK at 24°C Pressure drop See the enclosed diagram. Fire resistance The silencers are made from fireproof materials.

Inspection tank caps male threaded, in plastic material, complete with sealing gasket and fixing flange. We supply two different types of this product: Inspection cap for Ø 124 mm hole Inspection cap for Ø 215 mm hole We can also provide them equipped with safety chain. The inspection tank caps are generally used for canopies of power generators and on tanks of agricultural machines and industrial vehicles, spray dryer, water tanks and so on. We always guarantee quality and reliability of our product over time. We perform several strength and durability tests and tests for product quality control during the various processing phases. On request we can issue the relevant certificates in compliance with national and international regulations.

Flange gaskets made of Klingersil C4500 - DIN EN 1514-1 IBC Use: Special high-pressure gasket for alkaline media with very high temperatures and hot steam. Carbon fibers and special heat resistant additives bonded with NBR. High-tech material, especially in strongly alkaline media and in the steam area. Fire safety according to API SPEC 6 FA. DIN-DVGW permit, BAM tested, KTW recommended, certified TA-Luft.

During the construction of an industrial facility, much attention is paid to the strength of the service pipelines fasteners. It is also necessary to provide reliable connection of all units of industrial equipment with the pipelines. In this case, it is not always possible The use of a permanent welded joint is not always possible, therefore, there are various types of weld-free tight joints. FLANGE JOINT COMPONENTS At present, one of the most effective connections used in industrial facilities is a flange joint. This is an airtight connection that provides high structural integrity, consists of two flanges, fasteners (studs or bolts, washers, nuts) and gaskets. An important matter in choosing a set of flanges is tightness. The gasket material must have good elasticity, strength, resistance to the operating temperature conditions and to the media with which direct contact is expected. For flange joints, Villina company uses the following types

Flanges Flange gaskets Flanges for compensating pipes O-ring