The DATL/DAT dampers are designed for cladding with up to 50 mm thick insulation. The DATL/DAT dampers are a good choice when the ductwork closure must be airtight. The damper closure position can be read on the 0° to 90° dial of the control handle. The damper closure opening ratio can be fixed with a screw. DAT — airtight shutoff damper DATL — airtight shutoff damper with gaskets at flanged ends All DATL/DAT dampers of diameter 355 mm or greater have the damper closure pivot provided with extra bracing. All DATL/DAT dampers of diameter 450 mm or greater are supplied with the KITDSH damper mechanism control lever. Standard dampers are made from galvanized steel sheet.
Poland
The HomEvap adiabatic humidifier is designed for domestic mechanical ventilation systems with a maximum airflow 600 m3/h. Filtered water (Legiosafe®) naturally evaporates on a special matrix, and then the humidified air is distributed to the ventilation duct system and to the connected rooms. The humidification process is regulated by a wireless room controller and a duct sensor. Builtin PTC heater compensates for temperature losses caused by the evaporation process. The housing is made of EPP, while the matrix is made of fiber glass.
Request for a quotePoland
HHS wall diffuser for fresh air supply. Male connector with gasket for fast connection with SPIRAL® duct. Powder painted with white RAL 9010 colour which provides additional protection from corrosion in places with high humidity, such as bathrooms. An excellent choice when celling mounting is out of the scope or the interior design requires a wall diffuser. It can be used in offices, residential houses and mounted just under the ceiling as well.
Request for a quotePoland
The LDS linear slot diffuser are intended for ceiling or wall installation. The product can supply warm or cold air. The diffuser can feature from 1 to 4 slots, 495 mm or 990 mm in length, depending on the product version. Each slot enables separate air flow direction adjustment and is provided with two deflector vanes. This design enables easy adaptation of the air flow diffusion direction according to actual indoor conditions. With this easy adjustment functionality, the LDS linear slot diffusers are ideal for variable air output ventilation systems
Request for a quotePoland
GCR swirl diffuser is equipped with fixed blades bent at a constant angle. It is made of galvanized steel sheet, powder coated in RAL9010. Swirl diffusers ensure mixing of the fresh air stream with the room air, which is recommended for supplying cold air. They provide a stable flow of the stream and are intended for rooms up to 4m high, for example in public facilities such as hotels, restaurants, office buildings. The perforated plate leads to rapid air flow velocity decrease at low noise levels.
Request for a quote