control transformer Germany

... measuring receivers in the range of about 100 kHz to several MHz. The lower measurement threshold is rarely below 50 pC (pico Coulomb), even in shielded measuring locations due to disturbances. With the help of the TE filter, a partial discharge level of ≤ 10 pC can be achieved with the correct setup of the test field. This is necessary, for example, to operate test fields for transformers. The permissible partial discharge level depends on the power class of the transformer.

...Plug-in Current Transformer – AC Network Primary Busbar 127x54mm Primary Current 400…4000A Secondary Current 1A – 5A Burden: 3…50VA (PROTECTION) Class: 5P5 / 5P10 (PROTECTION)...

...Type E-UL Category Transformers Design Control Transformer (single-phase) Application Designed as a safety transformer with 24V output voltage separate windings with safe isolation through double/reinforced insulation Input for each type with 230V and 400V including taps with +/-15V Spring clamp terminals - user-friendly, time-saving, vibration-resistant all connections up to 0.2 - 4 mm² or AWG...

... of the PD200 e.g. through so-called safety ladders to the corresponding flat roof.The impulse current measuring system easily wins the weight comparison with its previous model. Although the single components partially are pretty heavy (e.g. the transformer), the total weight could be reduced by about 20% (from 11.2 kg to 8.6 kg). On top of the housing there are clearly visible signal lamps - one standard impulse signal (green) and one short-circuit signal (red), incl. integrated tone generator. Detected fluid:water Other characteristics:with visual alarm Applications:for flat roofs...

The nearly unlimited lifespan of our transformers and chokes is due to the continuous improvement of materials as well as qualified manufacturing. The high quality of our products and services is reflected in the years of experience and professionalism of our company. Our standard program - Single-phase control, isolation, safety, and energy-saving transformers in standard design or as customized...

... maximum stroke length of 700 mm. Lifting speeds of up to 18 mm/s (1,000 N) are available. The drive consists of a 24/36 V DC geared motor, which is typically powered via an external control/transformer unit (120 V AC/230 V AC-24 V DC) or, in the version with an integrated transformer, directly with 120 or 230 V AC. Features: • Two sizes available, "Medium" and "Large" • Suitable for tensile and compressive loads • Self-locking even under maximum load • Pre-set sliding units ensure play-free operation even after years of use • Built-in limit switches...

... Pt100 or pyrometer and the resistance is then corrected to the equivalent at e.g. 20 °C (adjustable) in the instrument. The application range is very wide such as the measurement of: — transformer motor coil windings — coils of all kind — cables and wires on the drum or as meter samples — switch and relay contacts — heating elements — fuses — connections and transitions at power rails and...

... Rogowski coil for current measurement) on HVline potential and transferred to the RemoteDataModule (RDM) mounted in the head construction of the instrument transformer. The RDM converts the recorded data into a digital serial protocol and transmits them via optical fiber to the Merging Unit (MU), located in the control room. The distance between instrument transformer and MU can be up to 1 km. The MU transfers the data protocol of three instrument transformers into the protocol according to IEC 6185092. For signal output ...

... (plasma). The connection between the transformer and the generator is plug-in. The electrode head is connected to the transformer via a hose that contains the high voltage and compressed air lines. The electronics of the Arcospot are modular; the individual components in the generator are arranged in a plug-in format. The connections for signal inputs and outputs are designed with connectors...

...The W 60 layer winding machine is an extremely stable, universally applicable machine for winding layer coils of all kinds, such as transformer, field, apparatus, disc, cylinder coils, etc. Thanks to electronic speed control, the winding speed can be adjusted continuously, allowing for optimal adaptation to working conditions. The wire laying is done via a servo linear guide unit and is also...

...Single-phase transformers and single-phase control transformers according to EN 61558 and EN 61558-2-13 Properties Insulation class T 40 / B open design separate windings foot angle creepage current safe transformer terminals hand and finger touch safe according to UVV (VBG 4) corrosion protection through complete impregnation IP 00, suitable for installation up to protection class IP 54.

...20 mA input control line U in 48 VDC...

... of bronze/stainless steel, in accordance with the regulations of the Drinking Water Ordinance and the recognized rules of technology such as DVGW, DIN, EN, ZSVHK, VDI, as well as the requirements of AGFW and the technical connection conditions (TAB) of the respective utility company. With thermal insulation (optional) With control cabinet Thermomatik or control via the building station Connection variants selectable Performance range according to hot water demand.

...These components are manufactured on closed core forms, usually using air gap-free ferrites. We produce a wide range of these transformers with basic insulation or reinforced insulation for safe electrical separation according to EN 60950 or EN 50178. Of course, we also manufacture transformers according to your specifications. Driver transformers are used to control power semiconductors and IGBTs.

...Adjustable Rotary Isolation Transformers, Adjustable Transformers, STTD, AC Sources, Alternating Current, Three-Phase Current Our adjustable transformers are used wherever a variable and stably regulated alternating voltage supply is required. For example, in testing, maintenance/repair, or in the development of electronics and devices. Particularly, the design as an isolation transformer...

...Separation Transformers / Safety Transformers / Control Transformers and Spar Transformers for General Applications and Stationary Use PRI: 100-500 V Frequency: 50-60 Hz SEC: 12-250 V Power: 10 - 1,600 VA Protection Class: IP 00 Operating Mode: S1 (Continuous Operation) Protection Class: I (Protective Earth) Ambient Temperature ta: 40°C Insulation Class: B (130°C...

... cardboard, die-cut pads, type PSP 3051, in formats - Transformer particle board, type PSP 3052, in formats - Transformer particle board, type PSP 3055, in rolls, narrow rolls, and formats - Transformer particle board as block board - Capacitor particle board, type PSP 3060, in formats - Capacitor particle board, type PSP 3065, in rolls, narrow rolls, and formats - Particle board substitute for non-electrical applications in rolls and formats - Eliteboard, colored particle chips in formats - Much available directly from stock, no minimum quantity from stock...

...Common type wires and terminals to provide a reliable connection between auxiliary voltage transformer and recloser control cubicle. Applicable product:Rec15_AI1_5p, Rec25_AI1_5p...

... application. Made of high-class transformer sheets and copper wire or aluminium band. Vacuum-impregnated with environmentally friendly, low-styrole resin for long operating life, high voltage strength and low noise levels. Standard terminals: copper terminal lugs, optional with screw-terminal blocks or cables. Integrated reversible thermal switch for monitoring of the reactor and control of external disconnection in case of overheating. Our standard range covers 400V 50Hz up to 300A per phase. Other values are available on request.

...Article Features * This clip-on current transformer is primarily used in the installation of new systems, as the circuit needs to be interrupted here. * Most cost-effective and common variant. * Transformer easily clips onto the primary conductor (no complex wiring required). * Currently the most compact design on the market, making it ideal for control cabinets. * Other application areas include machine and plant engineering.

...The primary windings of the transformers are typically equipped with taps at +/- 5% for voltage adjustment. Some variants of our control transformers are available upon request with UL construction approval. The control transformers are usually prepared with protective conductor connections on the sheet metal core for protection class I. To enhance dielectric strength and provide protection...

...Our Nano Solo is supplied complete with temperature sensor, motorized ball valve and GEKA-Plus couplings. Simply connect the Nano Solo to the power supply and the existing cooling water supply. Mobile individual fermentation control Motor ball valve or solenoid valve 1/2 inch Temperature sensor 5 meters with weight Connection cable with plug-in transformer 5 meters Stainless steel retaining plate for flexible assembly Protection class IP 65...

... bands • Process-related systematic fluctuations become visible and can be reduced. • Material, binding agents, and energy can be significantly reduced. • Can be combined with segmented scalper to FORMATOR Applications • Wood-based panel industry • Insulation material industry • Gypsum • Transformer board • Plastics...

... W1 or W2 – Control outputs 2 relays, potential-free contacts, 250V/2A – Output signal 0-10V, load min. 2k Ohm, terminals 1-2 – Auxiliary power 230V AC upon request at no extra charge: 24/110/120/240/24 V AC~; at an additional cost: 24 V DC...

...Transformer in savings circuit according to EN61558-2-13. Protection class IP20. Power specifications correspond to temperature class T40/B. Standardly equipped with touch-proof terminals 4mm² according to BGV A3. - Mounting on installation surface via base plate - Transformer for powering fan motors (speed control) Input voltage: 230V~ Output voltages: 160V / 130V / 105V / 80V~ Output current: 1.6 to 15A Nominal frequency: 50-60Hz Weight: 1.6 to 9.7kg...

... the alternating current (no harmonics, etc.), Ready for use immediately after installation and connection, Manufactured according to valid European standards (EN), Fully automatic control for low-maintenance operation, Monitoring including data logging and remote notification via SMS or email, Strict separation of power, control, and signaling circuits, Consistent use of reputable suppliers such as Schneider Electric, Rittal, etc.

...Beautiful light spheres for outdoor and indoor use. IP44 splash-proof. 12V 2W. Material: Polyethylene - UV, weather, and aging resistant. Includes power cable, ground spike, transformer, and remote control (ready to use). Warm white light as well as all RGB tones can be controlled via remote. Additionally, pastel tones and programs can be accessed through the remote for automatic operation. Light...

...); mains plug transformer (EP); MP: level indicator light, integrated 24V transformer. Soap supply hose up to a maximum distance of 2500 mm from the soap dispenser to the pump tank unit. Operating voltage 24 VDC, power consumption 7W (EP); MP - 5W (2P), 8W (3P), 10W (4P), 13W (5P), 15W (6P) Recommended soap viscosity 10mPa - 5000 mPa Standard response time for soap dispensing - 2.6 seconds. Adjustable 1.3 - 13 seconds via remote control. Number of soap dispensers: 4 stations ESEWTSP914 Single or multi-station supply: 40 34154 01930 0...

... transformer – our products operate worldwide under the most diverse conditions, reliably and safely over the long term. The individual designs range from simple and universal control transformers to isolation, rectifier, furnace, glow, ship, adaptation, multi-pulse converters, and high-current transformers.

...Electronic ballasts EPSA for UV discharge lamps with a maximum power of up to 40 kW. The rectangular output power of the EPSA results in a higher UV yield at the same electrical power, compared to the sinusoidal output power of conventional transformer/inductor technology. Additional features: • Stepless power control depending on application between 11% and 100% • Integrated igniter...