Line filter - Import export

Product Features: • Free standing IEC320 style high performance filter network including an earth line choke, and across the line VDR. Designed to work alongside electrical equipment where space is at a premium. • The PFM range of IEC inlet mains filters is available in 6, 10 and 16 Amps. • This range is typically a retrofit product where emissions and immunity issues have been discovered after the design has been completed. • Typical applications include computers and instrumentation which may be subjected to high levels of mains borne interference and voltage spikes. • Ideally suited for applications using IEC 60320 C13 power leads. • Designed to comply with BS EN 60950. • All products are RoHS compliant.

Product Features: • Intended for non-patient connected indoor applications where protection of sensitive electronics is required: • High end audio / studio use • Medical electronics • High end test equipment / laboratory • cULus Listed to UL 60601-1 (1st Edition) and CAN/CSA-C22.2 No. 601.1-M90 (R2005). • Each unit provides complete line isolation and noise filtering plus utilizes a Faraday shield to reduce leakage currents below UL60601-1 requirements (under 100 microamps). • Reduced noise coupling due to floating AC output. • Not included to be used to supply power to life support appliances. • 3 Different VA Capacities available - 500VA, 1000VA and 1800VA. All rated 50/60 Hz. • 4 Different electrical configurations: • 120V-120V Straight isolation ("178" Series) • 240V-240V Straight isolation ("240" Series) • 240-120V Step down isolation ("289" Series) • 120-240V Set up isolation ("298" Series)

Sold as a pack of two these In-line HEPA filters are used to filter the CO2 supply to CO2 Incubators but can also be used for N2 and O2 gas supplies. Technical Specification: Pore Size (in microns) = 0.1 Micron Dimensions: h. 53.7 mm; w. 53.5 mm Filter media: Ceramic Paper Filtration Efficiency: 99.9999%* Filtration Ability: 0.027 Micron Effective Filtration Area: 22 cm2 Ring Colour: White Connections: 8mm Inlet Barb on each side to fit 6mm ID hose Flow: Bi-directional Autoclavable: N/A NOTE: Quantity discounts available on this product. Please contact us for a quotation.

Colloide‘s Dynamic Sand Filter offers an excellent treatment system for the removal of solids and other contaminants from a water/wastewater stream. This filter is always on line, continually filtering the incoming water while continually backwashing a small portion of the sand bed. The Dynamic Sand Filter process: The feed water is fed into the filter at the base of the active sand bed through the distribution ring. It then flows upward through the downward moving sand bed where the solids are filtered out. The clean filtrate exits the filter through the overflow weir. The continuous reject flow of washing water is discharged through a separate outlet. The dirty sand is continuously removed from the active sand bed thanks to the action of the air-lift pump. This pump draws the contaminated sand from the bottom of the filter body. A mixture of sand, dirty particles and water is transported upward through the air-lift pipe into the washing chamber at the top of the filter.