Pressure relief valve - Import export

The safety valve is designed to protect the silo from damage caused by high or low pressure encountered during discharge and filling.

Diaphragm Safety Relief Valve (M-F) DN15-DN25 ** / Body : Brass ( CW617N-CuZn40Pb2) / Connection : Threaded / Type : Vertical Type / Max. Working Temp. : 120 ºC / Max. Working Pressure : 3,4,5,6,7,8,9,10 Bar *** Application Areas : Hot and Cold Water Systems

Body: ASTM A-536 Cast Iron / Valves : Bronze Surface covered with Teflon, Stainless steel Trim Set / Pilot control valve and system: Bronze ASTM B62 and Stainless steel 303 inner parts ** Connection Type: Flanged / Pressure :16-25 Bar / Working Temp.: +4ºC , + 80ºC *** This valves using for the preventing damages which cause from the pressure in fire pump systems. Generally fire protection systems use the diesel pumps and electrical motors. In that systems relief valves are preferred. **** Application Areas: In systems which has diesel or electrical high pressure fire fighting pumps.

There are hydraulic pressing clamps in the fixture equipment of system. The workpiece is both made spot welding by means of clamps and prevented distortion due to heat during welding. Separate control lever is used as to be put to rear of piston for each piston.Also there is a pressure relief valve on each control lever. Thanks to pressure relief valves the critical pressure is brought to the desired pressure and the compression of the material in desired strength may be achieved A lock valve is connected to each hydraulic cylinder after the tightening process and during the welding operation, the material is prevented from being retracted and opened due to heat input. Reverse deflexion may be done on the frame thanks to the control units in the clamp mechanisms. 1 inert gas arc welding machine will be used for spot welding process.( it will be supplied by the purchaser)

-Hydraulic Mini power packs -Hydraulic pumps, -Hydraulic Motors, Orbit Motors -Hydraulic power units and various hydraulic systems -Solenoid, Pilot, Manuel operated hydraulic directional control valves -Hand Valves -Relief, pressure, reducing, speed control valves, check valves, throttle valves -Modular and plate designed valves -Control blocks and hydraulic switch -Hydraulic Cylinders -Oil Coolers #hydraulicsystems #hydrauliccylinders #minipowerpacks #GearPumps #HydraulicMotors #HandValves

Test and Drainage Valves / Body: Brass ( Forged ) / Ball : Brass / Gasket : PTFE ** Connection Type: Threaded or Grooved / Working Pressure: 300 PSI ( 20,6 Bar ) / Working Temp.: -10ºC , +120ºC / Working Test Pressure: 600 PSI (61,8 Bar) *** In sprinkler systems, these valves are used for the testing systems and drain the unnecessary fluids from the systems. Advantages: They have sight glasses in their body,single valve is sufficient to drain the line. For choosing the test and drain valves, users should pay attention to line diameter. Also these valves have to have same diameter with the sprinkler orifice diameter. **** Application areas: The system where has sprinkler systems.