Damper - Import export

Dampers play a crucial role in the functionality of industrial ductwork as they are designed to control the flow of air or flue-gas within the ducts. The primary purpose of most dampers is to act as shut-off dampers. This means they are either fully open or fully closed depending on the operational requirements. However, some dampers are specifically installed to modulate the gas flow, allowing them to function in various partially open positions. The variability in damper functionality caters to different operating scenarios and provides flexibility in managing the flow of air or flue-gas through the duct system.

The bearings we have defined so far are the basic types, which constant feature is the fact that they allow all-ways movements and rotation. However, movements can be limited in one or all ways, thus obtaining guided or fixed bearings, respectively. In the first case -guided bearings- the restriction is obtained by means of guides parallel to the supporting axe that allows movement. To make friction as low as possible, PTFE and stainless steel sheets are welded to the guides.

BKD 100 TYPE AIR DAMPER BKD100 Type Air Dampers; are used for Air Handling Units, Ventilating Ducts, Industrial Air Conditioners to control air volume and to shut-up air movement. Features * Galv. Frame+Al. Blade * Al. Frame+Al. Blade * Stainless Leakage sheet * Manuel or Motorised Control * EPDM or silicone leakage gasket * Fiberglass Nylon Bearing * Parallel or Opposite Blade * Operating Temp.: -20C to 80C.

Exhaust gas bypass systems are made as additional equipment in exhaust gas heat exchangers. 3-way flap is required for bypass systems. By-passing the gas flow makes it possible to adjust temperature inside boiler (exhaust gas heat exchanger). Before delivery, we do a thorough test drive for every single damper, using actuator and special measurement equipment, to make sure that they function as expected and are ready to serve reliably on site. Availaible in steel, stainless steel or heat resistant materials Flange type and size depending on customer needs We develop dampers in different sizes and various temperature ranges Actuator options; Pneumatic actuator, Electrical actuator

TGS offers T-DAMPER Series in order to provide solution for inconvenient lid applications which requires movement control during opening, closing, lifting or lowering. T-DAMPER | Motion Control Series also reduce acceleration and avoid hard stops in the end position.

Material Specially rolled 6063 aluminum profile. It is used as a suction or blowing grille in the ventilation system. Surface Coating Standard coating is natural aluminum anodized. Optionally, electrostatic powder paint can be made.

Instantly measure and display of humidity and hectoliter of wheat Calculation of water flows according to the required humidity. Automatic water dosage according to the calculated water flow value Automatic water dosage according to the wheat flow variation by the connection of wheat flow control or measure unit Alarms of failure More than one humidity – hectoliter measuring unit and water the dosage unit can be controlled by the PLC control unit.

It is used in the grain processing plants, to ease the grain processing by neat and non-stop annealing and washing

It is used in the grain processing plants to moisten the grain at the highest desired rate up to rate of % 5-6.

It is used in the grain processing plants in order to moisture gradient into the grain

It is used in the grain processing plants to moisten the grain at a desired rate