Nickel steel - Import export

Spline shafts based on DIN ISO 14 with straight parallel flanks. A spline shaft with spline hub is used to transmit high torques while enabling simultaneous axial movement. The spline shafts are colddrawn. Cold drawing does not interrupt the grain flow of the base material, ensuring spline shafts of very high strength. Tolerances Straightness 0.8 mm/m. Torsion max. 0.5 mm/m. On request Other lengths.

Steel C45. Stainless steel 1.4305. Gunmetal Rg 7. Spline hubs based on DIN ISO 14 with straight parallel flanks. A spline shaft with spline hub is used to transmit high torques while enabling simultaneous axial movement.

Steel 1.0401 (C15) or stainless steel 1.4301 (whirled spindles stainless steel 1.4305). Version Steel rolled, bright. Stainless steel up to Tr 40x7 rolled, above this whirled, bright. Note Rolled, high precision trapezoidal thread spindles. ISO trapezoidal thread based on DIN 103. The trapezoidal thread spindle is a transmission thread with relatively high friction. Standard thread forms are selflocking. This has the advantage that they generally do not need to be secured in the rest position. Tolerance class 7e Pitch precision 0.3/300 mm Length sawed with excess, ends not deburred.

Single-acting pneumatic cylinder with two parallel working piston rods made of brass, nickel-plated or stainless steel.

Housing aluminium. Precision tube nickel plated steel. Trapezoidal thread spindle steel. Note The doubletube linear actuator can be operated manually or electrically. Due to the short duty cycle, the units can be adjusted several times a day at low speed and with high stability. Width, length and height adjustment possible.

KB RollerTech processes seamless metal belts (stainless steel and nickel). Compared to coated plastic belts, metal belts offer the following advantages: very high thermal conductivity very high physical stability Today, KB RollerTech processes metal belts with the following properties: Properties Nickel belts Stainless steel belts Length < 350 mm < 400 mm Diameter 15 - 50 mm 10 - 100 mm Wall thickness 30 - 500 µm 35 - 100 µm Geometry straight straight and concave Remarks 100 mm diameter only possible with seam Concerning the coatings the following combinations are possible: Nickel belts Stainless steel belts PFA sleeves PFA spray coatings or PFA sleeves Silicone and PFA sleeves Silione and PFA spray coatings or PFA sleeve

Scrap and waste of corrosion-resistant nickel-chromium steels with low nickel content.

Scrap and waste of heat-resistant chromium-nickel steels with a high content of chromium and nickel

Scrap and waste of heat-resistant chromium-nickel steels with a high content of chromium and nickel

Scrap and waste of structural steels alloyed with nickel and molybdenum, and their combinations with chromium, silicon, manganese and other elements, except tungsten.

10 - 75 CFM / 17 to 127 m³/h NASH has been providing vacuum pumps and packages in shipboard priming applications for over 50 years and continues to offer a wide range of classic products for this service. The single stage MD570, MD670, MHC, and MHF series are available in a variety of materials including bronze, copper nickel, and stainless steel. These pumps are provided close coupled to a marine duty motor have capacties ranging from 10 to 75 CFM. If deeper vacuum is required, the two stage AT34 &amp; AT64 pumps are available with capacties ranging from 30 to 75 CFM.

Lead Electrical engines Stainless Steel Nickel Bronze