Iron profiles - Import export

GJL 250 annealed or EN AW-7075. Drawing reference: machined faces: ±0.25 mm length tolerance: ≤200 mm: +3/+10 >200 mm ≤590 mm: +8/+15 ≥600 mm: +20/+50

The process of three-dimensional curving of aluminium, stainless steel, brass or iron profiles is carried out in two steps: torsion and bending. This is a very complex process, which only a high-skilled staff, with a technological equipment, can carry out.

The twisting or torsion of the extruded aluminium, stainless steel, brass or iron profiles is carried out via a clockwise (or counter clockwise) solicitation of the cross section against its axis. In order to avoid that this twisting jeopardizes the stiffening rib, we use a filling system to help the stretching and the compression of the fibres. We are able to twist up to 9 mt profiles!

Flexible drive solutions to meet the highest demands Key functionalities Low voltage application – nominal voltage adjustable between 24 and 60 V Continuous output range 60 - 880 W Peak torque from 0.1 – 40 Nm High dynamic range due to low moment of inertia Accurate positioning up to16k inc / rev Low cogging torque Optimized iron and copper profile Consideration of the non-linear magnetic field strength in the iron and air gap Optimal harmonic suppression by special pole geometry Large number of pole pairs