Gas compression - Import export

Here at Quality Air Service Limited we offer a refurbishment service of all Atlas Copco MD Desiccant Drums this includes replacement of the desiccant media, the top and bottom wear seals and bearings if required. This is a well established product and has been in the market for over 10 years. We offer a service exchange product this reduces downtime for the end user all we ask is the returned item is reusable (this is the centre core and stainless steel cover)

ALFAMAK is one of Turkey's leading gas spring manufacturers. Established in 2003, our company has been operating in the industry for 19 years and has gained a reputation for success. Gas spring is a new technology which comes instead of standard steel or polyurethane springs. A gas spring has a container of compressed Nitrogen gas with Piston Rod , Bush, Rod Rings, Valve etc. The Gas Springs are used in Cold Stamping industry to form, cut and fix the sheet metal inside the die. Many auxiliary materials are used for different purposes in the gas spring. Rod wiper, rod guide and rod seal are used on the inner surface of the bush. The purpose of the rod wiper is to prevent the oil and chips in the die from entering the gas spring. The rod guide is used to carry the load in case of axial force on the rod during use. The most important auxiliary material for sealing is rod/piston seal. It directly affects the performance of the product by keeping the gas in the gas spring.

Liquid chillers for low temperatures, also in outdoor environments The RW CW series of process fluid coolers (water, water/antifreeze) are water-cooled and operate with environmentally friendly gas compression. They allow cooled liquid temperatures between -8°C and +20°C. In standard design, ambient temperatures of up to +40°C are permissible, but in the “RW ax/HTA” version even higher ambient temperatures can be achieved. IP54 degree of protection as standard, allowing outdoor installation without a protective roof.

Gas assist molding is used to hollow out thick sections of a part where coring is not an option and sink is not acceptable. Gas assist molding can be applied to almost any thermoplastic, and most conventional molding machines can be adapted for gas assist molding. One of HODA, UAB activity is the plastic and rubber injection molding, using compressed nitrogen gas. We also provide assembly and packaging services.

Accessories / Dispensers Premium dispensers and foam guns Multifunction nozzles in different sizes for foam guns Substitutional spray heads, adaptor caps for pressure plumbers with compressed gas

Gardner Denver Nash’s HP and NAB compressors are the ideal choice for recovering fuel gas and condensing valuable hydrocarbons, making more money for the refinery. When reviewing the total life cycle cost of a flare gas compressor system, the NASH liquid ring system provides more value and better reliability than any other technology, hands down. Liquid ring compressors run cool and they clean the gas as they compress it–eliminating the need for downstream aftercondensers and scrubbers. The result is a simpler, more reliable system.