Control switches - Import export

Available in sizes 1/8 - 1/4 - M10 x 1 - M12 x 1.5 - 1/8 NPT Piston pressure switch with control ranges from 30 to 300 bar Diaphragm pressure switch with control ranges from 0.2 to 100 bar

With rotary control, two-way switch and soft-catch. 2-wire connection (neutral conductor not required) Optimised for dimming of retrofit LED lamps (LEDi). For dimmable Retrofit-LEDs (LEDi). For dimmable Retrofit-LEDs (LEDi) with conventional or electronic transformers. For incandescent lamps, 230 V tungsten halogen lamps, low-voltage halogen lamps with conventional or electronic transformers and dimmable energy-saving halogen lamps. Mix operaton of LEDi with conventional loads possible. Via mode switch adjustable between leading edge control and trailing edge control. Low-noise level by MOSFET transistors. With electronic short-circuit protection. With electronic overload protection. With adjustable minimum brightness. Without cover plate. Rated voltage: 230 V~, + 10% / - 10% Rated frequency: 50 Hz/60 Hz Nominal power: 2 - 100 W/VA (retrofit LED loads). Nominal power: 10 - 250 W/VA (non-LED loads).

Very small installation depth: < 20 mm Without claws. With rotary control, two-way switch and soft-catch. 2-wire connection (neutral conductor not required) Optimised for dimming of retrofit LED lamps (LEDi). For dimmable Retrofit-LEDs (LEDi). For dimmable Retrofit-LEDs (LEDi) with conventional or electronic transformers. For incandescent lamps, 230 V tungsten halogen lamps, low-voltage halogen lamps with conventional or electronic transformers and dimmable energy-saving halogen lamps. Mix operaton of LEDi with conventional loads possible. With manually adjustable operating mode: trailing / leading edge control. With adjustable minimum/maximum brightness. Low-noise level by MOSFET transistors. With electronic short-circuit protection. With electronic overload protection. Without cover plate. Rated voltage: 230 V~, + 10% / - 10% Rated frequency: 50 Hz/60 Hz Nominal power: 2 - 100 W/VA (leading edge control) Nominal power: 2 - 400 W/VA (trailing edge control)

SCHÜTZE spray valve KA 2 - NA Details as for KA 2 Additional equipped with a proximity switch for control of needle (open/close). nozzle and needle : stainless steel available nozzle dimensions: 0,2; 0,3; 0,5; 0,8; 1,0; 1,2; 1,5mm Ø

Brand New Cushion Filling Machine For filling and holding the cushion cover case, enabling the cushion to be put on with ease and speed Foot switch control simple operation low noise and safe to use reliable and economical It has six air cylinders that take all the work out of putting the cushion on in seconds This machine will do upto 600mm to 1000mm wide and fully adjustable for smaller cushio Quick setup; simply adjust width and cylinder stroke Utilizes the hopper method, rather than a vacuum; eliminates need for plastic liners and “sit down” noise High-volume output; up to four cushions per minute; 12-second cycle This machine provides high-volume output for almost any cushion or pillow. Its twelve-second cycle time fills cushions as fast as an operator can handle them – up to four per minute for some types of cushions. • No plastic liners needed due to utilization of hopper method. • Eliminates “sit-down” noise and the return problems associated with plastic liners.