Purifiers for water treatment - Import export

GENERAL DESCRIPTION MAKS 400P is super-threshold agent able to stabilize a wide range of supersaturated salt solutions. PRINCIPLE USES MAKS 400P is one of the principal antiscalants used by the membrane industry. For many years MAKS 400P has found application as an antiscalant and antifoulant in membrane systems using a wide selection of brackish, high salinity, process and effluent feed-waters. PRODUCT BENEFITS Highly effective antiscalant across a broad spectrum of waters Minimizes scale formation and reduces frequent membrane cleaning Reduces or replaces the need for acid Cost effective application due to low dose rate Compatible with all membrane types Effective iron sequestrant More stable and more effective than sodium hexameta-phosphate (SHMP) Enables systems to work at enhanced rates of recovery Extensive portfolio of toxicological and environmental data available NSF approved for use in potable water production up to 10 ppm (mg/l)

Waste water treatment plants and surface waters have enormous energy potential. A sewage treatment plant, for example with 90 million litres of wastewater daily, reducing the wastewater temperature by using heat exchanger by around 1°C, generates a power of about 4.3 MW. The comparative potential for energy recovery from the surface water is even higher. Environmental aspect Induced by humans, water temperatures of the surface and streams have steadily increased, not least owing to the inflows from sewage water treatment. This has serious consequences on the flora and fauna. If heat is extracted from purified water in the sewage treatment plant or from surface waters and from streams, and water temperature is thereby reduced, this will have a positive effect on the entire ecological system. With KASAG heat exchanger systems, on the one hand, the energy requirement of the sewage treatment plant can be covered and, on the other, buildings in near vicinity can be heated or cooled.

Microbial powder formulation designed to reduce mud build-up in ponds AG120 is a microbial powder formulation designed to reduce organic sludge build-up in ponds used for irrigation systems, wastewater treatment, etc. Ponds experiencing excessive organic sludge can benefit from this treatment as it is a cost-effective alternative to mechanical drainage which requires equipment (pumps, mechanical shovels, etc.) and whose sludge must be removed by time-consuming, expensive and potentially damaging operations to the bottom of the ponds.

Humidity strongly influences the spread of viruses, bacteria and other harmful particles in the air; especially rooms with dry air can increase the chance of contamination. Research indicates that a humidity level of >65% is advised to decrease the chance of viruses and bacteria spreading. The AirExchange Breeze is a professional air humidifier, equipped with a meshed prefilter that eliminates harmful particles from the air. The UV-C LED light-treatment purifies the water with an effectiveness of over 99.99%. The device has a timeless and stylish design and the mist outlet is made from pearl blasted, anodized aluminum. The internal heating function makes it possible to heat up the mist to a comfortable temperature of 39°C, which enhances the movement of the water molecules through the ambient air. The AirExchange Breeze has a water reservoir of 4.5L and a maximum mist output of 350mL/h, which is suitable for rooms up to 60m².

Humidity strongly influences the spread of viruses, bacteria and other harmful particles in the air; especially rooms with dry air can increase the chance of contamination. Research indicates that a humidity level of >65% is advised to decrease the chance of viruses and bacteria spreading. The AirExchange Breeze is a professional air humidifier, equipped with a meshed prefilter that eliminates harmful particles from the air. The UV-C LED light-treatment purifies the water with an effectiveness of over 99.99%. The device has a timeless and stylish design and the mist outlet is made from pearl blasted, anodized aluminum. The internal heating function makes it possible to heat up the mist to a comfortable temperature of 39°C, which enhances the movement of the water molecules through the ambient air. The AirExchange Breeze has a water reservoir of 4.5L and a maximum mist output of 350mL/h, which is suitable for rooms up to 60m².

We develop and manufacture intelligent automation solutions for engines, gear-boxes and auxiliary systems in one-off or series production. Each solution is manufactured according to your wishes and requirements and can be easily extended with additional displays and operating panels for decentral visualisation and operation. The intuitive visualisation is based on the powerful CODESYS software suite (IEC 61131) and can be adapted to your corporate design. All components are suitable for applications in harsh environments and ensure maximum operational reliability. Typical field of application is control and monitoring of: Propulsion engine Reduction gear-box Hybrid gear-box Trolling clutch Genset Others (e. g. winches, separators, purifiers, fresh and waste water treatment)

Our RO system offers a versatile production capacity from 250 to 4,000 liters per hour. It features a stainless steel high-pressure pump and a user-friendly 7" touch screen PLC interface. To ensure precision and efficiency, a digital flow meter measures production and wastewater quantities, and flow rates can be adjusted with a stainless needle valve. Pressure sensors on the touch screen monitor network and membrane input pressure, automatically stopping the system and displaying errors if preset pressure values are exceeded. Users can monitor the Total Dissolved Solids (TDS) value on the touch screen. The system includes three high-quality solenoid valves controlled by the PLC microprocessor for precise management. The electric panel ensures safety and longevity with Motor Protection and phase Protection functions. The system is housed in a visually appealing stainless cabinet.

GENERAL DESCRIPTION MAKS 4080 is a combination of heterocyclic compounds formulated in an aqueous solution. PRINCIPAL USES MAKS 4080 is a broad spectrum, non-oxidizing micro microorganism control agent for industrial open re-circulating, cooling systems, air washers, brewery pasteurizers and closed systems. It is designed to provide excellent control of microbiological growth, algea and associated deposits. MAKS 4080 is particularly well suited for use in systems with high levels of process contamination, as in the fertilizer, refinery, and chemical, industries. PRODUCT BENEFITS Effective against a broad spectrum of microorganisms over extended periods Helps to minimize slime problems which can cause costly reductions in heat transfer Minimum discharge problems; active molecules are environmentally degradable Easy to apply; active at low dosages. Organic based and can provide minimum 90% protection Does not cause precipitation; does not act with other additives

GENERAL DESCRIPTION MAKS 2911 is a liquid blend of specific organic film formers, organic scale inhibitor compounds, polymers and a surfactant. PRINCIPAL USES MAKS 2911 is an advanced "All-Organic" corrosion and deposit inhibitor for open-recirculating cooling water systems. lt is designed to operate at high alkalinities and hardness, minimizing or eliminating the need for makeup pretreatment. MAKS 2911 is effective over a broad range of application parameters. lt is best suited where the alkalinity in the recirculating system will be within the range of 100-500 ppm. The inbuilt chlorine stabilizer and biodispersant for better slime removal enhances the efficiency of oxidizing biocide programs. PRODUCT BENEFITS Controls scale formation at high alkalinity or high hardness conditions Effective corrosion protection on C-steel and yellow metals – “All Organic Inhibitor“ Multi corrosion inhibitor properties including Copper and Copper alloys Not affected by the use of chlorine

GENERAL DESCRIPTION MAKS 1300 is an aqueous blend of the neutralizing amines. PRINCIPAL USES MAKS 1300 is a neutralizing corrosion inhibitor designed for use in steam and complex condensate systems. MAKS 1300 can be used at steam pressures up to 160 bars and temperatures up to 4790C. REMARK: MAKS 1300 is in compliance with FDA regulations pertaining to boiler water additives. Maximum dosage in plants subject to FDA regulation does not to exceed 45 ppm in the steam. MAKS 1300 must not be used where the steam produced will contact milk or milk products. PRODUCT BENEFITS Neutralizes acid-forming gases like CO2 Provides corrosion protection in initial, middle and extended areas of condensate systems Reduces condensate system maintenance cost Minimizes boiler tube failures caused by corrosion product in returned condensate

GENERAL DESCRIPTION MAKS 1240 is a boiler feedwater treatment containing special polymers and phosphonates. PRODUCT BENEFITS Includes online cleaners removing scale and iron deposits during operation Designed to prevent scale and corrosion formation in feedwater boiler systems Prevents under deposit corrosion in boilers Reduces deposits, resulting in more efficient heat transfer, energy savings and fewer acid cleanings Designed for soft feedwater boiler systems FDA 21 CRF 173-310 approved Supports internal metal passivation in feedwater and boiler system Enhanced formula prevents activity loss during long term storage and usage

GENERAL DESCRIPTION MAKS 1100 is a catalyzed oxygen scavenger in liquid form. PRINCIPAL USES MAKS 1100 is an oxygen scavenger designed to control oxygen corrosion in boiler systems with/or without deaerators. MAKS 1100 should always be applied together with an internal scale/deposit inhibitor for a complete boiler treatment program. PRODUCT BENEFITS Reduces dissolved oxygen in boiler feed water systems to protect from corrosion Catalyzed form for faster reaction at lower temperatures Enhanced formula prevents activity loss during long term storage and usage Complies with FDA and USDA regulations in food industry, potable water, sterilization and steam humidification Can be used at pressures up to 40 bars

GENERAL DESCRIPTION MAKS 3000 is a non-chromate film-forming product in liquid form. PRINCIPAL USES MAKS 3000 provides maximum protection for mild steel, copper and yellow metals in closed cooling systems fed with distilled, demineralized or softened water. MAKS 3000 is widely applied in closed cooling systems of steel mills, power stations, refineries and many other industrial plants. PRODUCT BENEFITS Extends equipment life and reduces maintenance costs Environmentally friendly; does not contain heavy metals Compatible with antifreeze

LX Series is an industrial-level HypoX Sodium Hypochlorite Generator line with a wide capacity range that answers all industrial water disinfection requirements. LX Series is generally used for large-scale water disinfection requirements of municipality drinking water treatment facilities, swimming pools and aqua parks, large-sized industrial process water disinfection, and cooling tower. With its own chemical synergy of Fresh and Mix Oxidants besides hypochlorite, HypoX® LX Series guarantees to solve important problems like Biofilm, Odor, Legionella, and Strong Pathogens. The high disinfection performance of HypoX® LX Series makes it an effective, economic, green, and safe alternative mainly to chlorine and other biocides in chlorination requirements Applications Areas - Large scaled drinking water&wastewater treatment plants - Swimming pools and aquaparks - Industrial process water treatment - Cooling towers - Reverse Osmoses Process water

At Grünbeck, we have developed a deferrization installation that uses the best technologies for removing iron from groundwater: the fermaliQ. This iron removal installation combines oxidation with filtering, thus removing odors caused by hydrogen sulphide or ammonium.

"The rEvap technology is the perfect solution for small and medium-sized companies that want to close material cycles and minimize disposal costs. The plants are equipped with a plate module. We would be pleased to carry out appropriate preliminary tests for you. Technical details: For process water / waste water up to 1 m³/h Fully automatic Controlled via Siemens SPS Adaptable according to customer requirements All channel geometries possible Suitable for endurance run"

"The main customers of our MDLab are universities, institutes and companies who conduct research and practical studies on membrane distillation. This highly precise laboratory set up is fully automatic and suitable for the investigation of all aspects of the membrane distillation process as well as material research e.g. on membranes. The MDLab is equipped with a flexible test cell, which can encompass any MD channel configuration or material sample. Our MDLab system can be visited in Freiburg on appointment for a full demonstration. Technical information: 120 cm x 140 cm x 85 cm Fully automated Tablet controlled (Terra tablet included) Customizable according to specific rquirements All MD channel configurations possible Suitable for continuous operation Power supply required"

"SolarSpring's MBS-Wall-Mounted is a compact and innovative water treatment system. The system guarantees a reliable and safe water supply from polluted and microbiologically contaminated water sources without the use of chemicals. Technical data: Nominal flow rate: 100 - 600l/h Energy consumption: 8W Weight: 32kg"

"The MBS-Outdoor from SolarSpring is a compact and innovative water treatment plant.The system guarantees a reliable and safe water supply from contaminated and microbiologically contaminated water sources without the use of Chemicals. Tecnical data: Nominal flow rate: 50-200l/h Energy consumption: 40W Weight: 22kg"

Are you looking for a water softener for your industrial process? You may be confident that when you buy a Grünbeck water softener, you're getting a high-quality, cutting-edge installation. Our GENO-mat® and Delta-p® softening systems have shown to be a trustworthy option for softening in hotels, trade, and industry. The Delta p series from Grünbeck, for example, has the lowest pressure loss of any water softener on the market. This saves you energy and water! Take a look at our various models.

Aluminum sulphate has a very important place in food, health, water treatment, fertilizer, feed industry and industrial production. Drinking water treatment is the most common use. Because it is a very good filtering agent, it is used for the process of removing undesired material from the environment by collapsing the production process. As a pH regulator in agriculture it helps to enrich the soil with mineral.