• europages
  • >
  • COMPANIES - SUPPLIERS - SERVICE PROVIDERS
  • >
  • oil pressure switches

Results for

Oil pressure switches - Import export

Turkey

An engine oil pressure switch is used to maintain power to the engine, and the vehicle, once the engine has started. When the engine is cranking, power is being supplied through the starter circuits. However, once the engine is running, and the oil pressure is up, power is routed through the oil pressure switch and sensor unit. This is done to ensure the engine is not run without oil. If the sensor does not read the right pressure, the switch will not close, and the vehicle will not stay running. The pressure switch is generally place or fitted around the Engine Oil filter as the oil line has to pass through the filter to be filtered during its continuos cycle of use.

Request for a quote

Turkey

An engine oil pressure switch is used to maintain power to the engine, and the vehicle, once the engine has started. When the engine is cranking, power is being supplied through the starter circuits. However, once the engine is running, and the oil pressure is up, power is routed through the oil pressure switch and sensor unit. This is done to ensure the engine is not run without oil. If the sensor does not read the right pressure, the switch will not close, and the vehicle will not stay running.

Request for a quote

Netherlands

Verified by Europages

Pressol electric Oil pump set mobile model 23001960 Complete with trolley 17009 with 4 meter hose and oil gun digital with 30° spout 1/2"G 19698950 Mobile oil system for 220 liter drum Electric oil pump 23321 with pressure switch suitable for oil up to SAE 90 Yield maximum 10 liters per minute, maximum pressure 10 bar Suction tube with bend and foot valve, G 3/4" female, G 2" male (19 523) Check valve (84 546) Suction hose, 2 m, G 3/4'' female/male (19 512) Transit hose, 5 m, G 1/2'' female/male (19 565)

Request for a quote

Turkey

Verified by Europages

Is a mineralautomotive gear oilthat has been developed for alltypes of gear operating under normal conditions. It does not contain extreme pressure (EP) additives, so it is suitable to use in gear systems, synchronized transmissionsand differentials not operating under high load.

Request for a quote

Turkey

Verified by Europages

Compressor pressure switch, rated at 150 PSI.

Request for a quote

Do you sell or make similar products?

Sign up to europages and have your products listed

Add my business

Slovenia

Wide supply voltage range 7 to 40 V Wide compensated range (0 to 70°C) Total accuracy down to 1% over 0 to 70°C, all effects included (maximum) Standard 0.5 to 4.5 V analog output Digital I2C output up to 15 bits (pressure + temperature) Overcurrent and overvoltage protection Overload and short circuit protection Standard M8 output connector Gage configuration 20 mBar – 7 Bar, or vacuum

Request for a quote

Turkey

The function of a Pressure Switch is to provide a path for an electrical circuit that is triggered at a certain pressure. Example uses are: •Oil pressure warning light in an automobile •Pump controller (turn well pump on and off) •Air compressor control •Industrial process signaling A pressure switch must have a process connection (usually threaded for a pipe or tube) and an electrical contact that is connected to wires or terminals. They may sense rising or falling pressure and most are adjustable, so the contact will engage (or turn on the electrical circuit) at a desired pressure setting. They can be pneumatic (air and gases) or hydraulic (water, oil or fluids) or even strictly mechanical. The internals can be a diaphragm capsule, a small chamber backed by a spring or a bourdon tube. The contact is usually copper points but can also be a mercury (in glass) tip switch. Unlike Pressure Transducers which give an analog electrical signal proportional to the amount of pressure, these

Request for a quote