Pipe locator - Import export

The air purifies the flour dust mixture from flour dust, traps the flour dust and ensures that clean air is expelled from the chimney. Flour dust captured by specially woven bags returns to the system. Thus, flour loss is prevented. The filter section body is made of 2-6 mm sheet metal and the lower part is a cast iron plate. The transmission and engine parts are located on the cast plate. The gearmotor is mounted on the transmission as a battery. The transmission located in the filter section drives the steel plate arm also located in this section. There is an air suction cup on this steel arm. This air suction cup closes the filter bags on its upper part and located in the pipe section, one by one, at regular intervals (with the help of the transmission movement arm) and sucks the product inside. Meanwhile, the clean air included with the product

International patent registered for the CLEAN ROOM SYSTEM line (DIN EN ISO 14644-1) The CLEAN ROOM SYSTEM units are linear actuators with belt driven transmission and are specifically designed for Clean Room applications They are supplied with a certificate issued by the IPA Fraunhofer Institute in Stuttgard, which certifies compliance with class ISO 3 (DIN EN ISO 14644-1), or with class Fed Std 0.01 (FED 209 E). The system prevents particles from being discharged in the environment where the linear unit is located. This has been achieved by using a special straight seal that closes the horizontal opening where the slider moves, as well as by the operation of a 0.8 vacuum pump connected to 2 vacuum pipes located inside the drive head and the idle head. The system allows vacuum to be generated inside the unit so that any particles released when the system is operating are sucked towards the air filtration areas. Clean Room System linear actuators components are all made of...

This is the most installed version of the fabric expansion joints (KOREMA® type A3 or AC3 as well as B3 or BC3). The name »flange-type« is used for expansion joints located between pipe or duct end flanges. For existing plants, the flange design varies according to customers’ requirements or depending on the constructed steel design. For innovative designs KOREMA® will identify the suitable technical and economical solution. Special design: supplied as »open« multilayer expansion joint. On-site service available exclusively from the KOREMA® service team. Insulation is incorporated to protect the expansion joint against abrasion as well as for thermal insulation. The choice of insulating material, either mineral wool or ceramic felt, depends on the design temperature. For operation at or below dew point, a vulcanized elastomeric layer is available. Pre-assembled units, complete with liners and clamp bars, are available.

Villina-VS1-М, Villina-GNVC-K and Villina-GNGC-K type centrifugal canned pump units with combined seals are widely used in modern gas industries, petrochemical and petroleum refining industries. They are designed for transiting neutral, corrosive, toxic, as well as explosive and flammable liquids in stationary conditions, the vapors of which can form explosive mixtures with air. For such conditions, mechanical seals with operating temperatures up to 425°C of well-known companies are used, such as: OOO NPC ANOD, JSC TREM ENGINEERING, UNICHIMTEK Group of Companies and others, as well as permanent magnets (SmCo) with operating temperatures up to 450°C. Villina type units are made in three versions as regards the spatial location of the pump rotor: vertical ground-level (Villina-VS1-M) - the pumped liquid is supplied to the pump part of the unit through a suction pipe located radially to the pump rotor. The unit consists of a pump part, a device