Steel bending - Import export

We can supply you with highly wear-resistant stainless steel pipe bends which have a service life 10 to 20 times longer than that of standard stainless steel pipe bends. This high degree of wear protection is required, for example for conveying fibreglass-reinforced plastic granules or similarly abrasive media. suitable for use of highly abrasive products easy installation no stepped pipe couplings and no flange connections required safe for use with food

The advantages to you: no more deformation of roundness when cutting bends on site easier extension-pipe/tiered pipe bend construction appealing visually pickled surface All of our pipes and pipe bends (both unannealed and annealed) are made of the following material: stainless steel pipe, material no. 1.4301 (AISI 304) longitudinal seam welded pipes hot rolled & cold rolled coils, unannealed, with or without pickling (W1) Make: IltaInox and/or Marcegaglia

Our speciality are thin-walled pipe-bends with large bending radius, especially for pneumatic conveying systems. The pipe-bends are cold-bent without any pleats on CNC-mandrel machines. Our quality management generally guarantees: welded seam smoothed or shaved (DIN 11 850 resp. DIN 17 457) absolutely wrinkle-free, no start-up bulges no scratching or scoring extremely low ovality visually aesthetic surface leg extension each side deburred sawing edges

Glass pipe bends For conveying abrasive media or for high flow rates, we can supply you with glass pipe bends made from 3.3 borosilicate glass with a copper grounding strip. These have a service life at least 10 times longer than that of stainless steel pipe bends. made of 3.3 borosilicate glass leg extension 200 mm copper grounding strip attached at the outer radius

The measuring element of the load cell consists of a double bending beam on which strain gages are applied. The applied force detunes the measuring bridge so that a proportional output voltage is generated. The strain gages on the measuring element are protected against dirt and water spray by a rubber bellows. The sensor can be easily mounted via two mounting holes. The tension or compression force to be measured is introduced at the opposite end perpendicular to the sensor axis. Due to its special design, the influence by an extension (e.g. touch finger) on the measuring signal is low. Overload protection can be realized with little effort using a mechanical stop. FEATURES For tension and compression forces Measuring ranges from 0 ... 5 N to 0 ... 2 kN Relative non-linearity: ≤ ±0.1 % F.S. Very low mounting height Simple force application Material aluminium or stainless steel Special design on request burster TEDS optionally available

We will provide you with pipe couplings for different outer tube diameters e.g. to connect glass bends with stainless steel tubes. DVK-6 pipe couplings for suction conveying can be delivered in the following sizes: 47.0 to 40.0 mm 56.0 to 50.0 mm 66.0 to 60.3 mm

lasercutted sheets bended in hard-tool for mid-range batches, high flexible, batches from 1.000 - 50.000 parts

Description - crease-free bended - ends cleanly deburred bends (stainless steel).pdf