Results for
N&H TECHNOLOGY GMBH
Germany
The Loresta GX is used to measure conductors and semiconductors in the lower resistance range. Measuring range: 10^-4 – 10^7 Ω. It is used to measure the surface resistivity (Ω / □), the volume resistivity (Ω · cm), electrical conductivity (S / cm) in the low-resistance range. The Loresta-GX works according to the 4-pin measuring method. The method is based on the four-wire method and was developed to eliminate the influence of contact resistance. The measuring heads consist of four needle-like electrodes. To simplify the measurement method and calculate the correction factors, all four electrodes are at an equidistant distance from each other. Conductive Materials: Paints, pastes, paints, printing ink, Smart Textiles, Plastics, rubber Film materials, metallic thin films, metallised films, resistor pastes amorphous silicon / silicon wafer, antistatic materials, EMC shielding materials ...
Request for a quoteTAMPOPRINT GMBH
Germany
TAMPOPRINT offers a wide range of ink/doctoring cups for "hermetic" standard pad printing machines. Available are sizes with diameters of 30/40/60/90/130/140/150/210 mm in plastic, aluminum or steel with ceramic or carbide doctoring ring. Multi-color ink/doctoring cups, pressure rings and pressure ring adapters are also available. The ink/doctoring cup is used in the "hermetic" pad printing process to transfer the printing ink to the cliché in a single operation and simultaneously remove the ink (doctoring).
Request for a quoteAFS ENTWICKLUNGS + VERTRIEBS GMBH
Germany
Measurement of the surface tension The adhesion of a surface is usually directly dependent on the surface energy. If the surface energy is substantially lower than that of the printing ink used, the wetting is disturbed, resulting in poor adhesion. For this reason, plastic surfaces have to be pre-treated. Depending on the type of ink used the surface tension required can vary: solvent based inks => 38 bis 42 mN/m (=Dyn/cm) water soluble inks => 40 bis 44 mN/m UV inks => 44 bis 46 mN/m With the test inks of AFS, which are available from 34 to 56 dyn/cm surface tensions of plastic films can be easily and reproducibly determined according to DIN ISO 8296. Depending on whether the ink sticks or bubbles on the surface it indicated whether the surface tension is above or below the dyne-value of the currently used test ink. We also offer the test inks in a case with 12 bottles from 34 to 56 dyn/cm.
Request for a quoteDo you sell or make similar products?
Sign up to europages and have your products listed
Results for
Printing inks for plastics - Import exportNumber of results
3 ProductsCountries
Company type