Bitumens - Import export

For tar or hot bitumen at temperatures from –25°C to +200°C. With additional spiral for maximum safety and highest possible flexibility. Construction: Special NBR tube Tension and pressure-resistant fabric inlays Embedded copper wire Concealed steel spiral abrasion-resistant CR-cover interior and exterior smooth, fabric patterned Please follow the safety regulations for bitumen hoses! Tar spraying hose Bitumen hose Sold by the roll or cut to length with cuffed ends and/or widened hose endings. Also available as heatable version or per DIN EN 13482. Other versions and dimensions on request.

These particularly long sealant collars were specially designed for sealing up anchorage points on a bitumen roof surface. They are 300 mm long and available in two models: For anchors with or without an additional supporting tube (Ø 16 oder Ø 42 mm). The discs are 420 mm in diameter. The collars have also been marked with a series of practical notches which make it easier to shorten them. Sanded or slated - for bitumen roof surfaces Suitable for Ø 16 and 42 mm supports Extra-long: 300 mm Notches cut into the surface every 20 mm allow the tube to be shortened in a straight line Incl. shrink tubing Disc diameter: Ø 420 mm

Secure your domed rooflights using this 1100 mm-high guard rail made of aluminium and stainless steel. It protects your workers from falling off the roof or putting a foot through the rooflight. This guard rail system is suitable for flat roofs with a pitch of up to max. 10°. It can be installed on bitumen or fabric-reinforced plastic sheeting to provide a completely penetration-free solution. EN 13374:2013, A Designed for flat roof pitches ≤ 10° Suitable for domed rooflights: Max. 2.5 m x 2.5 m Handrail height: 1100 mm Weight per post: Approx. 3 kg (traditional posts 30 kg) Set includes bitumen patches PVC patches need to provided and cut to size onsite

Install this stainless steel anchorage point (Ø 16 mm) - specially-designed for flat roofs (max. 10° pitch) - on bitumen or fabric-reinforced plastic sheeting without penetrating your roof surface - and without the need for extra weights. The crossbars, which are made of high-quality, lightweight aluminium, ensure that the force is reliably distributed whilst keeping the weight down. Meets the requirements of EN 795:2012, A + CEN/TS 16415:2013 Designed for flat roofs with a pitch of up to 10° Min. 15 m² roof space required Fused to a bitumen/fabric-reinforced plastic membrane Penetration-free installation - no extra weights required

Use one of these collars to seal up an anchorage point with or without an additional supporting tube (Ø 16 und Ø 42 mm). This sealant collar is available in two finishes for use on a bitumen roof surface: Sanded or slated. The disc is 420 mm in diameter. We supply this collar with matching shrink tubing. Seal for bitumen roof surfaces Sanded or slated For Ø 16 mm and Ø 42 mm rods Shrink tubing included Disc diameter Ø 42 cm

Use this system to test the load-bearing capacity of the subsurface when conducting the annual inspections of your ABS-Lock OnTop fall arrest device for bitumen and fabric-reinforced plastic membranes. The set consists of 2 circular, stainless steel testing units. For testing the subsurface Suitable for bitumen and fabric-reinforced roof membranes

With ABANO nozzle technology, approx. 15% less drive power is required. The power not required can additionally be used in the suction area. The cross-sectional area of the nozzle inserts is also reduced by approx. 15%, which creates an increased pressure size at the insert (low back pressure approx. 1 bar).