Products for glasses - Import export

A sensor only is not a responsible for good measurement. Often it depends on the surrounding conditions. Thick-walled glass-capillary-sections serve for the sensor as solid basis. Fitted on top, the sensor is mostly islolated from thermal and other environmental impacts. Solid connections between glass and metal For the production of glass-feed-throughs or glass metal sealings, precise cuttings of capillary-tubes are needed. These special tubes are glasses, which are adjusted to the physical parameters of the metals. We draw and cut such capillaries precisely to final size. Thereby the glasses can be fused on the customers wires and pins, which are made of metal. Scatter discs for the endoscopy Glass rings in different sizes with two satin cut sides, allow to manufacture small ring lightings for example for the endoscopy. By means of the rough surfaces of the glass rings, the light, coupled on the back, is refracted and diffusely spread. Different diameters and thicknesses as...

Tachograph DTCO

Cleaning card for the Bill Validator from JCM, microfiber surface, dry or damp in the bag.

The microfiber surface cleans the chip contacts and the card / pullthrough slot; the special arrangement of the microfibre means that the dirt particles are absorbed deep into the cleaning card and are not released again.

The cleaning card was developed for ATMs and bank statement printers. The microfiber surface cleans the magnetic head and chip contacts. The feed rollers are embedded and cleaned by the special length of the microfibre.

Complete Set

Polyester resins (UP resins) form the basis of our product range in the glass fibre reinforced plastic systems business area – with a wide variety of applications. They range from thixotrope standard systems for manual lamination and fibre spraying to low-viscosity standard formulations for polymer concrete and sanitary applications to numerous special formulations for specific requirements. With a broad spectrum of properties and applications, our UP resin systems are suitable for products in a wide variety of industries. Typical properties Dense matrix / composite of approximately 1.1 g/cm³ / 1.5–1.7 g/cm³ Fibre content 25-50 % of total weight Moulded part mass per unit area of 4500-8000 g/m² Flexural modulus of elasticity 5000–25,000 MPa (with reinforcing mesh) Bending resistance of 130–260 MPa (with reinforcing mesh) Impact resistance of 45–95 KJ/m² Reinforcing materials: Continuous or cut glass fibre mats, fleece Mesh Non-crimp fabrics Special formulations and versions Styrene-reduced, environmentally friendly formulations Low-viscosity injection resins with reduced exothermic peak Formulations for the pultrusion process Systems with high chemical and hydrolysis resistance DIN 1140 versions with special mechanical values and dimensional stability under heat greater than 100 °C (HDT > 100 °C) Resins with good adhesion for combination with PVC Resin systems with shipping industry approval: Det Norske Veritas/Lloyd’s Register of Shipping/Germanic Lloyd Coordination with gel coat/top coat for surface refinement Flame protection formulations Electrical industry: UL 94 V0 Rail vehicle construction: DIN 5510 (S4, SR2, ST2)