Wooden plates - Import export

secutex – the gentle power against raw impact forces. If screwing or welding is not possible, just glue the secutex where impact protection is required. No problem with the secutex special bonding material. These are the advantages by gluing (nearly) everywhere applicable No drilling or welding necessary Bonding where welding or screwing is impossible Applications Thin to medium thick wood plates Glass and plexiglass Sound absorbing elements Fine wood surfaces Examples Coolhouses Painted, laminated, veneered walls and surfaces According to special requirements A proper bond requires always a good preparation … The following procedure is needed 1. Cleaning of the surface Suitable grease and siliconedissolving cleaning agents are required. This step is important to ensure that there is no dirt on the surface which may be present during the grinding or sandblasting process. 2. Roughening the surface Sandblasting or grinding of the surface are especially suitable here.

Simply clamp this stainless steel anchorage point (Ø 16 mm) onto a beam (max. 150 mm) using its base and counter plates. Do the dimensions of your beam differ? Upon request, we can also supply anchors with national technical approval in custom sizes. National technical approval ("abZ"): Z-14.9-688 (pls. observe the installation instructions provided in the "abZ") EN 795:2012, A + CEN/TS 16415:2013 Clamped onto a wooden beam using a base and counter plate (max. girder width: 150 mm) Add a supporting tube for usage as an end or corner post in a lifeline system Incl. stainless steel installation set Available for other beam sizes upon request

Thanks to its special base plate, this stainless steel roof safety hook can be flexibly adjusted to fit the angle of your roof surface. The cranked shaft is designed to bridge the battens. It is installed by screwing the 2 stainless steel screws supplied through the counter lathing and into the beam below. Roof safety hook in accordance with EN 517:2006, type B Anchorage point + ladder hook Designed for load-bearing wooden structures Base plate allows flexible installation Simply screw it onto a wooden beam (also suitable for over-rafter insulation) Min. beam dimensions: 60 mm x 120 mm