Installation of pumps - Import export

Designed as in-tank suction strainer elements for direct installation into suction lines of pumps; should always be installed below the minimum fluid level of the reservoir Features ▪ Available with female BSP thread (ISO 228) or female NPT thread (ANSI B1.20.1) Materials ▪ Threaded end cap made of glass-fibre reinforced Polyamide (PA) or Aluminium ▪ Lower end cap and support tube made of Steel, zinc-plated ▪ Standard filter material is Stainless Steel Mesh (125 μm); alternative micron ratings of 60 μm and 250 μm on request Consult STAUFF for alternative materials. Media Compatibility ▪ Suitable for use with Mineral and Petroleum based hydraulic fluids (HL and HLP) Technical Data ▪ Operating temperature range: -20 °C ... +100 °C / -4 °F ... +212 °F ▪ Integrated bypass valve with an opening pressure of 0,2 bar (3 PSI) to reduce the risks of high-pressure drops that can be caused by contaminated strainer elements or high-viscosity fluids Special sizes, designs, materials and...

Technical data Design Dual plate check valves to be mounted between tow flanges according to EN 1092-1 Type 11 form B – PN10/PN16. Face to face EN 558-1 row 16 Connection DN50 … DN300 Mounting position Pay attention to the flow direction. Preferably mounting into a horizontal runing pipeline. Make sure to install a minimum of 5 x nominal diameter of straight pipeline in front of and behind the dual plate check valve. Do not install the valves directly onto a pump flange. Pressure range PN10 … PN16, see table Temperatur range 0°C … +80°C Media Non aggressive liquids Material Body: GGG-50, FBE-coated Flap: Stainless steel 1.4408 Stem and spring: Stainless steel 1.4401 Seals: EPDM The above information is intended for guidance only and the company reserves the right to change any data herein without prior notice!

Technical data Design Dual plate check valves to be mounted between tow flanges according to EN 1092-1 Type 11 form B – PN10/PN16. Face to face EN 558-1 row 16 Connection DN50 … DN300 Mounting position Pay attention to the flow direction. Preferably mounting into a horizontal runing pipeline. Make sure to install a minimum of 5 x nominal diameter of straight pipeline in front of and behind the dual plate check valve. Do not install the valves directly onto a pump flange. Pressure range PN10 … PN16, see data sheet Temperatur range 0°C … +80°C Media Non aggressive liquids Material Body: GGG-50, FBE-coated Flap: Steel, nickle plated Stem and spring: Stainless steel 1.4301 Seals: EPDM The above information is intended for guidance only and the company reserves the right to change any data herein without prior notice!