Beam installation - Import export

The sensor element consists of a double bending beam with applied strain gages. Changes in the ohmic resistance of the strain gage fullbridge caused by applied forces are converted into electrical voltages. The precise value (characteristic value) of the output voltage, resulting from the application of a rated force to the sensor, is specified in the accompanying calibration protocol. The sensor has to be mounted by two screws on the cable side. The opposite side is meant to receive applied forces (loads). Once the rated stress or strain is exceeded by 20 %, further deflection of the bending beam is prevented by an integrated, mechanical stop. This protects the sensor element against permanent deformation.

The mounting solution for T-beams Fast and easy installation We would be very pleased to support you with all your individual questions and suggestions regarding WUS. Give us a ring or leave a message indicating the information you need. We will contact you as quickly as possible. Your WUS team

If you are looking for an unobtrusive anchorage point to secure up to 3 individuals, simply attach this stainless steel anchor loop (Ø 5 mm) to a wooden beam. Once installed on a pitched roof, this anchorage device is virtually invisible. All you need for quick-and-easy installation are the 2 stainless steel screws provided. EN 795:2012, A + CEN/TS 16415:2017 Virtually invisible anchorage loop Designed for load-bearing wooden structures The loop is simply screwed onto a wooden rafter (also suitable for over-rafter insulation) Minimum rafter dimensions: 60 mm x 120 mm

This reinforced, stainless steel anchorage point (Ø 16 mm) comes with a special supporting tube (Ø 42 mm) and includes an angular plate for lateral installation. Simply drill 2 holes through a load-bearing beam to install it. Our standard package includes threaded bolts and nuts for countering. EN 795:2012, A + CEN/TS 16415:2013 Angular plate for lateral installation Designed for load-bearing wooden structures Minimum beam dimensions: 100 mm x 200 mm Incl. stainless steel installation set

The impact elements consist of three components that are connected to one another by hot vulcanization A special rubber compound with a hardness of 62 ° Shore A, which absorbs the falling energy A top layer made of high sliding UHMWPE and a thickness of 10 mm A vulcanized aluminum profile for easy installation of the beams Special bolts with M16x40 also available in M12