power supply modules

...The Dragonfly battery is designed to enable measurements in areas where power is not available from the local power grid. •,Capacity of 100Wh (power supply of a typical Dragonfly amplifier for up to 10h runtime) •,One battery module can also power several Dragonfly amplifiers (with correspondingly shortened runtime) •,Several modules can be combined to extend battery life. •,Can be used as a UPS (Uninterruptible Power Supply).

...Analog-controlled and short-circuit-proof high-voltage power supplies in a compact design for PCB mounting. Including a monitor output for the output voltage. The APS, BPS, and CPS are small DC/DC high-voltage modules for direct PCB mounting. The output voltage can be adjusted via a potentiometer or control voltage. -Power supply: Depending on the type, 5V, 12V, and 24VDC -Output: up to 6kVDC and 8W with negative or positive polarity -Low residual ripple and noise, low electromagnetic interference (EMC) -Internal reference voltage -Custom modifications available upon request...

...Used for protection against power outages as well as under- and over-voltage wipos UPS: Input DC UPS 24-30: 22.5-28 V / 35 A UPS 20-960 UPS-DC/DC combination device: 12-48 V / 20 A...

...DC-DC converters of the SMM (1.5W), SMN (2.5W), and RMM (1.5W) series are cost-effective high-voltage modules for PCB mounting with output voltages up to 15kV. The output voltage is proportional to the input voltage. By using an external feedback, a regulated output voltage can be generated if needed. Application notes provide a selection of such circuits. In the DC-DC converters of the RMM series, the output is highly isolated from the input, allowing the modules to be used with either negative or positive output voltage (output reversible).

...At J. Schneider Elektrotechnik GmbH, you not only get the ultracapacitor modules (UC modules), but also the appropriate charger depending on the application. This way, you receive a coordinated system from a single source. If you cannot find a suitable UC module in our standard range, we would be happy to develop one for you upon request. Whether it’s about a specific housing or the electrical values, we are here to assist you in obtaining the right UC module for your specific application.

... installed. The new module copies the firmware from the installed modules. Automatic upgrade of the rated power happens when more UPMs are installed. Install the new UPS module, and the device automatically updates its rated power. With UPS-as-a-Reserve technology, excess power is fed back into the grid directly by the UPS, or in case of shortage, power is drawn directly from the grid. This way, the UPS contributes to GREEN IT and balances supply and demand for electricity. For an ecological energy economy (EnergyAware).

...The IM82-24 series switch-mode power supplies are suitable for 24 V power supply of DC consumers, particularly for interface modules from our IM, IMS, and IMC series. The devices are mounted on DIN rails and meet the protection class IP20. The output current is – depending on the type – 2.5 A, 5 A, 10 A, or 20 A. With the wide input voltage range, the power supplies can be used worldwide. Additional features include high efficiency, temperature resistance, and dynamic overload capability.

...In-line filters for currents from 0.5A to 1000A in various designs. A comprehensive range of EMC filters for single-phase and three-phase systems. In addition to in-line filters up to 1000A rated current, there are also IEC input filters combined with switches/fuses or small modules for printed circuit board mounting. In all power classes, there are both 2-stage filters with a very wide attenuation spectrum and 1-stage filters for a more narrowly defined interference spectrum. For connection, there are variants with screw terminals, plug connectors, or threaded bolts.

...UPS system with a capacity of 6, 10, or 20 kVA. Cabinet suitable for up to 5 or 10 modules and with rack-mount options. Low noise.

...The LED profile for commercial surfaces, stores, and supermarkets in the LDS series is a linkable linear LED lighting system. This allows us to achieve outstanding performance. The LED modules, power line, and control are integrated into the fixture, making installation easier. This LED profile is made from aluminum alloy. It implements SMD LED technology using specialized lenses, allowing it to...

...From 1 to 7 modules, from 0.6 A to 8.4 A. Narrow version 1 module, Compact version 3 modules Optional charger module...

...Experience the power of sustainability with the Mendel Powerbank, crafted from rABS. With a potent 5,000mAh capacity, it serves as your trusted energy source for devices on the go. Enjoy a robust 22.5W output via cable (USB-C) and 15W output wirelessly, with the added convenience of magnetic charging. Choose the Mendel Powerbank to stay powered up while making eco-conscious choices.

Founded in 1989, Necron Elektronik Yazılım Mühendislik A.Ş. proudly maintains its leadership as Turkey's leading Combi-UPS manufacturer, specializing in uninterrupted industrial power supplies. Our company, recognized for its visionary innovation, has marked significant milestones in the industry. Starting with a facility of 4,500 m² in Tuzla Organized Industrial Zone, we transformed into an effic...

... DC for the supply of plant instrumentation. They can be used together with power feed modules. FieldConnex® is the optimal infrastructure for connecting fieldbus devices. The efficient design of the fieldbus power supplies ensures easy deployment and high availability. Power Hubs are power supply systems using termination board technology and can supply up to four FOUNDATION Fieldbus H1 or PROFIBUS PA segments.

...The PSC303 series power supply modules are very compact DC/DC converters with an optimized circuit design, resulting in high power density.

...• Bridging power supply through the DIN rail bus connector (CB-Power-Bus) • Redundant power supply • Built-in over-voltage (surge) protection • Supply of up to 75 modules • Two individual power supply sources can be connected to one SINEAX VS70 module • Spring cage clamp connection...

...1- and 3-phase power meters and single-phase current/voltage transducers - SensAct are communication-enabled monitoring devices with a Modbus RTU interface for monitoring in energy applications and industrial plants. The modules reliably measure current, voltage, power, energy, and a variety of other electrical parameters in single or three-phase networks and transmit the data via Modbus RTU to a PLC or another evaluation device (data logger).

...The MUST 10-400 range is a modular double conversion online inverter for sensitive equipment. With power ratings from 10kVA to 400kVA, it offers the best combination of reliability, functionality, hot-swappable capability, and flexibility at a competitive price.

... company in the world in the field of drives and controls to hold the status of "Bosch Rexroth Service Point." Therefore, we are able to offer you a warranty of up to 24 months* on the services mentioned above regarding the power modules from the manufacturer Bosch Rexroth/Indramat.

...KIN-48/230-3 inverter cassette possible to install up to three IN-1.0/48М inverters up to 1000 W each. Cassette with installed inverters provides connected equipment high-quality AC power. Parallel operation up to 4 inverter cassettes with a total power up to 12 kW or construction of a three-phase system on three cassettes is possible. Modification with optional bypass module available. RS-485...

...ELECTRICAL POWER SUPPLY, DIN RAIL MOUNTED, 230V AC / 12V DC / 60W - 5A - non-redundant This model is designed for powering locking and access control products. This power supply provides 12V DC with a maximum of 5A across two outputs; it occupies 5 modules in an electrical cabinet. A LED indicates the presence of mains power.

... – 264 VAC. The 120W Ultraslim IP67 metal case power supply from GPT Trader Electronics comes with a two-year warranty. Dimensions: 160*60*17 mm This 120W power supply has an IP67 ingress protection rating. It is quite resistant to small particles such as dust, moisture, and/or any water particles. Ideal for use with LED strips or LED modules, such as banners, signs, stretched ceilings, decoration, and kitchen modules.

... ✓ Extended functionality by UPScom management software ✓ 3 years warranty The compact DC UPS modules UPSI-2412DP2 in a robust DIN rail housing are ideally suited for long-term use in control cabinet applications and decentralized solutions for protecting embedded industrial PCs, controls, motor drives, sensors, measurement devices, safety technology and many more. The UPS comes with USB & RS232...

... length or mains cable Optional, on request: Output power: 20Watts and more Optional, on request: Combined variant with connector and cable Optional, on request: Customized output voltages Optional, on request: Current regulated version for LED application...

... module. An optional Dryer module can increase the purity from 99.9% to 99.999%. The optional Water Purification System (WPS) can provide the needed water with the quality of < 20 µS/cm. A Water Tank Module (WTM) can be installed and stores 38 l of deionized water. It is equipped with a pump which provides the needed supply pressure or the electrolyser modules. The WTM takes the space of one electrolyser and is needed when no direct water supply can be provided. Also it is recommended when more than one cabinet will be installed parallel. ...

... voltage and current source and offering a variety of optional features, the device is suitable for a wide range of applications. The power supplies can be used redundantly with decoupling diodes. The modules can operate independently or with system monitoring.

...The new B3 Battery is a battery motor designed for demanding and efficient pumping applications. Its independent power supply allows for maximum flexibility with the highest flow rate of any battery pump in the world (up to 180 l/min). Perfect for extracting or transferring concentrated acids and alkalis. * Media examples: hydrochloric acid, chromic acid, sulfuric acid, nitric acid, hydrofluoric...

... fully flowing sensor - Maintenance-free - Power supply / voltage supply 24 V ± 10% - Mechanical Luerlock connection according to DIN EN 1707 -... Output signal: 0.1 to 10V Operating temperature: 15 to 45°C Flow rate: up to 100 ml/min (depending on the medium) Electrical connection: Material functional channel Material functional channel: FFKM Material housing: anodized aluminum Material encapsulation: PU Mechanical connection: LUER-LOCK DIN EN 1707 Measuring range: 0 to 16 bar Power supply: 12 to 30 VDC...

...Pack of 2. Chains of 70 LED modules X1 white IP 67, Modules for upholstery Recommended for a box height of 90 mm - 140 mm Lifespan: 80,000 h Color temperature: 6500° K Luminous flux (lumen): 60 lm LED beam angle: 160° Consumption: 0.60 W per module (42 W for a complete chain) Power supply: DC 12V Color rendering index (CRI): >83...

... of roll alarm (optional) Electronic control unit Switch Stroke counter with zero setting Protection fuses Potentiometer for speed adjustment of labeling head Power supply 220 V 50 Hz. Dimensions mm.