temperature controller

... The controller itself needs a supply voltage between 85 - 305 VAC. Application specific firmware is needed for the unit to function. This firmware can be downloaded via Senteraweb, our online HVAC portal, where we already made a limited number of specific firmware version available, used in typical HVAC applications like destratification. The only thing that needs to be done is to select the appropriate functionality on the solution page of our website and download the firmware. No additional programming is required. TCMF8 is also available - for AC fan speed control. ...

... configurable via external signal input: 10V DC signal or temperature sensor PI Parameters for PI Algorithm Maximum Output Voltage Control Effect Positive / Heating or Negative / Cooling With the differential pressure and volume flow controller DPC200, you can measure the smallest differential pressures of non-aggressive gases, particularly air. An analog output signal of 0…10V is available, and depending on the device settings, this signal has different meanings.

... storage, the boiler, or solar collectors. Optionally, the D30 heating controller can also be equipped as a boiler control panel with a safety temperature limiter (STB) and a 7-pin burner connector. Included in the delivery are the wall or boiler mounting base, as well as external sensor, flow sensor, and immersion sensor for the boiler and water heater. Thus, the heating controller can be optimally used in both new buildings and existing heating systems. The D30 heating controller also features a highly efficient heat source switching with demand-based burner request at...

...-404 offers a comprehensive solution to optimize your operations. Modbus Connectivity and 1-Wire Sensors: The X-404 enables extensive monitoring through Modbus RS-485 connectivity for up to 32 devices and the 1-Wire Bus for up to 16 temperature and humidity sensors. You can easily view and adjust Modbus/RS-485 registers via its built-in firmware.

... a wide variety of thermal fluids. - Hermetically sealed compressors and electronic leak detection technology minimize the risk of potential gas leaks. - Low noise design for noise-sensitive environments. - The LCD display provides a wide view of operational parameters. - Microprocessor controller for precise and reliable operation. - Can be enabled for remote control and GSM. - Portable container...

...In terms of controls, we offer more than most competitors, in addition to simple PID controllers. For example, we provide control optimization for a performance-driven district heating extraction. This not only measures the temperature at the outlet but also the effective performance. Also available: complete visualization of a district heating network, controls for heat exchangers, or steam systems in hospitals, and more.

...Batch Registration and Ordering of Applications The RA33 Batch Controller is designed to record flow rates and control output signals for valves and pumps to achieve precise dosing of predefined quantities. The measured volume can be adjusted using the temperature/density compensation function. The filling process can be optimized with automatic or fixed correction of residual flow. Mineral oils can be corrected according to the ASTM D125004 standard. Calculations: Volume Calculation...

...-hermetically sealed compressors and electronic leak detection technology minimize the risk of potential gas leaks. - Low-noise design for noise-sensitive environments. - The LCD display provides detailed visualization of operating parameters. - Microprocessor controller for accurate and reliable operation. - Can be enabled for remote control and via GSM. - Portable galvanized frame with ISO 4-point...

... +/-1.5 Pa – Display units Pa, kPa, daPa, mbar, mmWS, mmCE, in.W.C. – Ambient temperature 0 . . . +50 °C; – Housing wall mount IP65 – Three-point step controller with P(I)D behavior two setpoints (W1/W2), adjustable from 20…80% of the measurement range, switchable via external contact (terminals 3-4) – Switch LCD position top: display of the actual value "X" position bottom: setpoint display...

...The CXup series offers exceptional features in its class: In addition to a PWM charge controller with temperature compensation and an LCD, CXup controllers are equipped with extensive control, programming, and safety functions.

...WiFi Controller is a versatile lighting system. Thanks to the WiFi function, mobile devices can easily control different types of LEDs after installing the associated application. WiFi controller offers 5 types of controls : dimming, temperature settings of white, RGB and RGB White. It also allows up to 12 zones to be controlled individually using the WiFi repeaters. WiFi controller offers 5 types of controls:dimming, temperature settings of white, RGB and RGB White...

... Available real-time data: Solar power (W), Solar voltage (V), Energy yield (Wh), Battery voltage (V), Battery charging current (A) Real-time display of error information from the connected device Ability to set parameters for battery type and temperature directly via the remote display Data displayed graphically on a large screen Simple and intuitive operation via 3 touch buttons on the front of the display No external power supply required Protection class: IP20 Communication transmission: RS485...

...The DeltaSol® A, DeltaSol® AX, and DeltaSol® AX HE controllers are the simplest solution for all differential control applications. The DeltaSol® A version features an adjustable temperature differential and a frost protection function. The DeltaSol® AX version is an advanced model that additionally includes a minimum or maximum temperature limit. Equipped with an electromechanical relay and a PWM output, the DeltaSol® AX HE takes on the speed-controlled operation of a high-efficiency pump. The included silicone sealing cord provides protection against dripping water.

...Universal PID controller for two-point and three-point control applications as well as continuous control applications. All programming can be conveniently done via the free Windows software.

...The sensor is connected via an extension cable with an M12 connector. Please order the extension cable type M12CM separately. Thermocouple types J, K, T, and E Equipped with single or dual thermocouples Non-grounded measuring tips Temperature range of the connector -50 to 260°C Molded four-pole M12 connector, protection class IP65 Flexible sensor Connector contacts made of thermocouple material Thermocouple cable available in thermocouple material Vibration resistant according to MIL-STD-202G, Method 204D, Test Condition A, 10 g from 10 to 500 Hz, for lengths up to 150 mm Minimum length 65 mm...

...Actuator for the actuation of the Engine Start/Stop button in vehicles. Stand-alone controller with buttons for position selection and external selection via potential free contacts. Positions: - Idle position - Ignition On / pre-glow / fuel cell pack power-up - Engine Start / stop Simple set-up with key pad. Temperature resistant actuator in fail-safe design with mechanical, spring-actuated...

...Room Temperature Controller for Ribbed Tube Heaters The desired room temperature is set to a fixed value, and the controller is then sealed. The ribbed tube or pipe heater and temperature controller now reliably maintain the selected temperature. Adjustment Range: -20 to +30°C Accuracy in K: 1 to 3 Switching Power in A: 16...

...SHTC Range - Hot Channel Temperature Controller...

With precision and craftsmanship Sought-after quality from Central Hesse Quality is in demand – this is confirmed day after day by the numerous orders from our customers. The inquiries extend far beyond the borders of Germany. Individual service, meticulous work, responsive production, and delivery are our strengths. With the establishment of Dressel Temperature Measurement Technology GmbH in 1...

...Digital Temperature Indicator Standard version with independent battery power supply...

...The GD-02T temperature probe is an accessory for the versatile GSM transmitter and controller GD-02-DIN. It is necessary for using the temperature measurement functions and managing temperature limit values.

... : Federal Republic of Germany Technical data Measuring range Density: 0 - 3 g/cm3 Temperature: 5 - 95°C (regulated Peltier thermoelement) Pressure: 0 to 10 Bar (0 to 145 psi) Density Resolution: 0.0001 g/cm3 Precision: ± 0.0001 g/cm3* Repeatability: ± 0.0001 g/cm3 Temperature Resolution: 0,01°C Precision: ± 0,05°C Repeatability: ± 0,02°C Measuring time: < 30 sec. ** Sample volume: approx. 1.5 ml Filling: By injection Bubble detection: combined visual – electronic Operation: Touchscreen, Keyboard /Mouse /Barcodereader /Remote via PC User Interface / Display: 7" color touchscreen, 800 x 48o...

...Digital temp controller and digital timer ...

...Our reliable fermentation control Nano Fix is suitable for professional fermentation control in breweries and cellars. The Nano Fix with temperature sensor, motorized ball track and plug-in power supply unit, single fermentation control ideal for breweries and wineries Without electrical installation Actual and target display Motor ball valve 1/2 inch Temperature sensor with 6mm diameter All cables with a length of approx. 5 meters EU version...

...The video output broadcast allows the AX8 to deliver a live video stream from all installations and produce automatic alarms. INDUSTRIAL PROTOCOLS Compatible with Ethernet/IP and Modbus TCP, enabling easy transmission of analysis results and alarms to a programmable logic controller. COMPACT AND EASY TO INSTALL The AX8 measures only 54 x 25 x 95 mm and can be easily installed in tight spaces to ensure continuous monitoring of equipment. Field of view: 48° x 37° Temperature measurement range: -10°C to 150°C Accuracy: +/-2°C or +/-2% Dimensions: 54 x 25 x 79 mm...

...Water storage container for storing 30 concrete test cubes (in 2 layers) at 20°C according to DIN EN 12390-2 Plastic container with feet and lid robust, compact straight design, ideal for changing locations complete with slatted frame and heating system electronic controller with digital temperature display overheating protection, level shutdown via second measuring sensor password-protected digital temperature control...

...Automated valves play a central role in process engineering: they regulate flow rates, block product streams, and release pipelines. The challenge lies in ensuring that the valve and actuator harmonize perfectly, taking into account specific customer requirements. Automation technology simplifies complex systems, ensures a lower error rate, and consequently speeds up work. Temperature range: –40 to +80 °C Housing: Aluminum painted with DD paint Connection type: Pneumatic and electric Actuation system: Single-acting and double-acting Protection class: IP 65...

... power consumption • -40°C to 85°C operating temperature range • 44-TQFP (10x10) package • Alternate packaging available in tray Applications: The Microchip Technology Network Interface Card (NIC) ENC424j600-I/PT is ideal for a wide range of embedded Ethernet applications, including industrial automation, medical equipment, consumer electronics, and automotive. It is also suitable for applications...

...The ZOOM controller has been specifically developed by the BASCHILD Research & Development Department for the integrated management of dryers, evaporators, pre-dryers, and high-temperature chambers. The interface is customizable and easy to use. With ZOOM, it is possible to dry anywhere and with any device.

... Serial and SPI), and LB (PCIe to Local Bus/ISALike) for different kinds of applications. The AX99100, in a 68-pin QFN package, is available with RoHS compliant packaging and supports a commercial grade operating temperature range from 0 to 70°C and an industrial grade from 40 to 85°C. PCI Express Singlelane (X1) PCI Express Endpoint Controller with integrated PHY compliant with PCI Express 2.0 Gen.