impeller pump Italy

...The valve isolates pumps from the system during pumps starting and stopping to protect pipe lines and pumps itself. The valve is equipped with a control solenoid valve that is switched on at pump starting and is able to fulfill pipe line gradually, reducing pressure rising peaks and allowing soft starting of the pump with closed outlet. The valve controls pump stopping as well, gradually closing before sending a closing signal to the pump. In case of casual pump stop, the valve acts also as an automatic check valve, preventing backflow over the impeller.

...Peripheral volumetric pumps capable of developing high pressures relative to modest flow rates and powers. - Brass impeller - Mechanical seal in ceramic graphite - Closed self-ventilated motor - Class F insulation - Single-phase power supply 230V 50Hz with thermal protection and permanently installed capacitor - Three-phase power supply 230/400 V 50Hz with user-provided protection - Maximum water temperature: 90°C Pump body: cast iron Shaft: stainless steel AISI 416 Protection: IP44 Maximum pressure: 6-8-9 bar...

... and temperature sensor Jet Ring system Max Capacity [m³/h]:250 Max Head [m]:78 Impeller diameter [mm]:490 Discharge [mm|in]:100-3.9 Solid Handling [mm|in]:35-1.4 Weight [kg]:600 Motor displacement [cc]:108 Max. oil flow rate [l/min]:160 Max. pressure [bar]:300 Power [kW-HP]:80-108.7...

... cover, motor casing, pump body, impeller: G20 cast iron Motor shaft: AISI 420 stainless steel Electric cable: 10 m in H07RN-F Asynchronous, 2 poles, lubricated with non-toxic oil, insulation class F, protection degree IP68 Flow rates: 0 – 280 lt/min Head: 0 – 24 m Power: 1.1 – 2.2 kW Motor shaft: AISI 420 stainless steel Electric cable: 10 m in H07RN-F...

... pre-cake suspension homogeneous, thereby limiting the interspace between the tank and drum • Pulp input by means of an electric reversible positivedisplacement pump • Filtered fluid drawn off by means of a submersed electric pump • Pulp deposit on the drum surface regulated by an impeller • Thermostatic control ensures low water consumption for the vacuum pump liquid ring Especially effective...

...Hydraulic rinse aid dispenser included. Electrical setup for detergent dispenser. Electrical setup for drain pump. Use of round baskets without supports. Stainless steel detergent injector welded to the tank. DVGW valve. Speed of rinse and drain impeller rotation. Washing jets for printers. Technical specifications Power 3.26Kw, pump power 0.26kw/0.35Hp, Tank heater 3.0 Kw, tank capacity 13lt Washing cycle 120sec. dimensions 42x50x59.5 Dimensions of square basket 35cm...

...CTO Series Construction Vertical shaft centrifugal pump series "CTO" with closed impeller and inline connections. The "Pull-back" design allows for disassembly of the pump without disconnecting the volute from the piping. The coupling lantern houses the standard IEC B5 electric motor, which is connected via a telescopic rotor shaft to the impeller. The mechanical seal is standardized according to...