bar equipment Germany

... 2,000 bar and 10 Hz can be generated. With the test circuit for hydrostatic and burst pressure tests, pressure ramps up to 3,000 bar can be generated. It is operated on a support arm PC. For pressure tests according to EG79 / EU406 – Section 4.2 Pressure booster for additional supply Displacement volume max. 15cm³ Frequency up to 10Hz Pressure Load Changes as sine & trapezoidal curve...

... applicable EU standards. Usable films: Polypropylene, composite, aluminum, barrier, polyethylene. Performance: 30-80 bags/minute Bag weight: up to 1,000g (higher weights with support flap) Bag size (width/length/opening): 50/60/150 mm to 800/1000/350 mm Diameter of film roll: up to 320 mm Packaging material: PE or thermally sealable composite film Film thickness: 10 - 120 μ Power supply: 230V (single-phase) Air supply: 6 bar Machine weight: 400 - 1,000 kg...

... - including basin floor reinforcement Technical data: - required water pressure: 1-4 bar - Water connection screwable 3/8 inch - Dimensions: 270 x 110 x 115 mm Weight: 2.3 kg Country of origin: Germany Manufacturer: Geppetto Eis...

...BORSIG supplies synthesis gas boilers for gas pressures up to 350 bar (35,000 kPa) and steam pressures up to 160 bar (16,000 kPa). They are used in the synthesis gas loop of ammonia plants. The boilers are equipped with U-tubes and can be mounted both in the vertical as well as in the horizontal positions. With both designs, the steam drum can be integrated into the boiler if requested by the customer. At the same time, a feed water pre-heater can be installed in the boiler when required.

... connection is done by M5 inner thread. On request all pressure regulators can be adapted to different pressure levels or set to a specific output pressure. Seals can be changed from NBR to EPDM or Viton (FKM). Thereby it is easy to adapt the regulators to special media as oxygen (O2) or drinking water (H2O). Max. setting pressure:4.0 bar Type of pneumatic connection:M5  Pressure range:0 - 10 bar...

... transmission and archiving of up to 6 analogue and digital input signals. Product features For daily, monthly, annual evaluation; meter statuses, operating times and volumes; min., max. and mean value recording Multi-colour display, digital, bar chart and graph representation Archiving in the internal memory and on compact flash card (no data lost in the event of a power failure!) Remote data transmission via standardised interfaces Suitable for door installation in the AWAcontrol control cabinet ...

... system" for wear through deviations in oil condition values o configurable specific limit values o precise real-time data • modularly implementable oil sensors • numerous options for data transmission • optional automatic data interpretation • also suitable for high-viscosity oil • also suitable for oil with air entry / air bubbles Sensors: • pressure sensors (bar) • moisture sensor (RF in %) • temperature sensor (°C) • sensor for oxidation rate • particle content (>4, 6, 14, 21 up to 250 micrometers (µm))...

...9 cm or less This door pull-up bar works with counter-pressure and adheres firmly to the door frame. Improved special support feet made of TPU, without any discoloration. White door protectors, specially developed and revolutionized to protect your frame. Maximum loads of up to 300 kg, thanks to a solid steel construction. Simply unfold, hang it up, and get started! The comfortable silicone grips are durable and provide a secure hold. Our grips offer comfort and grip. Ergonomically angled grips protect your wrists.

...At cash points, receptions, kiosks, snack bars, and for talking with customers in the services field – this hygiene screen can be assembled in a flash and, thanks to the service hatch, is really versatile. Designed for: Bar counters (standing) Tables (seated) Ceiling mounted Material:Plexiglas Material thickness:4 mm Dimensions:W 1,000 x H 900 mm ...

... - Fast change of media - Effective use of reagents - Cost and time saving Applications - Instrumental analytics - Micro-reaction technology - Biotechnology - Diagnostic - Analyses in the Life Science sector - Laboratory Automation Typical... - Flow rate: pump-specific 0.015 - 72 *ml/min - Smallest dosage volume: 0.25 µl - Differential pressure range: pump- and valve-specific 0 – 5 bar * - Maximum...

... extremely flexible in their design and can be offered in various variants and equipment thanks to a modular system. Differential pressures up to 120 bar, suction pressures vacuum up to 15 bar Temperatures up to max 500 °C in combination with a magnetic coupling. Viscosities up to 1.000.000 mPas or higher Components made of stainless steel, ceramic and special materials Flow rates from...

...Individually adjustable suction of the stem. Weight: 1.8 kg Stroke: 18 mm Max. nail Ø: 3.4 mm Pressure: 5 - 7 bar Pulling force at 7 bars: 11,700 N Noise: < 75 dB(A)(68.32) Air consumption: 2.4 liters Pneumatic connection: G 1/4 internal thread, left or right...

...Combination of household comfort through ceramic cartridges and lightweight design through plastic housing. The spout and adjustable shower head (jet or spray, or completely shut off) are extendable with a hose (150 cm). Heat-resistant up to 3 bar. Optional equipment with microswitch.

...Short description: PU sewer jetting hose, 250 bar GrüloJet 250 is a thermoplastic sewer cleaning hose that has been developed especially for the equipment of professional sewer cleaning vehicles. The pressure carrier, consisting of double-braided highly tearproof aramid- and synthetic fibres, guarantees long endurance and therefore decreases your expenses. The GrüloJet 250 is floatable and...

... water protection areas and in buildings. Made of HDPE with integrated galvanized steel sheet catch basin Equipment: Level indicator, optical leakage indicator, integrated carrying handles, suction kit, 4 m filling hose, digital hand flow meter, holder, and drip cup. Pneumatic pump 3:1 (not calibrated) - Gear ratio 3:1 - Operation at 6 - 8 bar - Max. delivery rate 14 l/min - Compressed air connection ¼" IG, medium outlet ½" IG, suction connection 1" IG - Air consumption approx. 330 l/min - Operation only with maintenance device - Pumping medium oil up to SAE 90 Attachment parts for...

... sealing surfaces made of stainless steel Spring-loaded, hydraulically released brake with unidirectional freewheel coupling Roller bearing planetary gear throughout the winch mechanism Typical performance data of the winch: at 115 bar and 23 l/min with standard motor 36 m/min, max. 27m rope at d = 6 mm...

...Heating with high-pressure steam up to 5 bar Pneumatic actuation of the basket Basket perforation tailored to products Temperature controller and cooking timer...

...Application: Ro-Ro Landing Systems Piston-Ø:720 mm Stroke:3850 mm Pressure range:up to 300 bar Drag force:1800 to...

... width 700 mm height about 850 mm (optional changeable) mass 120 kg Compressed air required 2-8 bar Material:steel, aluminium Surface:powder coating...

... never be open at the same time, allows for very good sealing of differential pressures. electric drive: four standard sizes: 250, 315, 400, 500 mm and up to 0.4 bar differential pressure pneumatic drive: 250, 315, 400, 500 mm and up to 0.5 bar...

... status is recognized, and the door and buttons are automatically operated. Kinematics and Gripper Simple and understandable movement pattern. The gripper is individually customizable. Technical Data Loading Box Max. Reach: 850 mm Max. Load Capacity: 20 kg Dimensions: 1950 x 1200 x 1200 mm Power Supply: 230 VAC, 50-60 Hz Pneumatic Supply: 6 bar Control: SIEMENS SIMATIC S7 Door Automation: Integrated Mobility: on wheels (optionally with floor rail).

... Convection: EC tangential fan Heating: ECP KaControl: integrated System: 2 pipes Grid models: - FineLine Q (cross grid) - FineLine L (linear grid) - bar spacing 4.8 mm Heating capacity 1) [W]: 248 - 3524 (with hot water 75 / 65 °C, air inlet temperature = 20 °C)...

...For installation into pipes to the protection of vessels and components against deflagration of flammable liquids and gases. Approved for all substances of explosion group IIA1 (old: I) with a maximum experimental safe gap (MESG) ≥ 1.14 mm. Bi-directionally working in pipes, whereby an operating pressure of 1.2 bar abs. and an operating temperature of 60 °C must not be exceeded. The distance...

...Span 0 - 80 mm Robust aluminum construction Self-adjusting clamping system Load capacity per handle 100 kg Guaranteed non-slip across the entire span Rubber-coated bar to protect the load Item number: 8117000 Weight: 2.600 kg...

...Basket diameter: 400 mm, Basket load: 70 kg, Filling capacity: 30 l, Spray pressure: 1.3 bar Pump performance: 60 l/min Pump motor: 0.40 KW Voltage: 240/400 V Timer: 0 - 60 min Weight: 40 kg...

...Versatile overpressure stage (single-stage) for plant construction. Drive: belt-driven or directly coupled. Very energy-efficient, robust, durable, and low-maintenance. Available in 10 power levels up to a maximum of 355 kW. Flow rate: 69 to 3,180 m³/h Overpressure: 13 bar (g) Pumping medium: air and neutral gases...

... for intuitive machine operation in service and automatic mode for production and cleaning operations. 1: Double jacket for heating and cooling 2: Feeding via vacuum 3: Liftable mixing tool 4: Pressure shock resistant up to 12 bar 5: Electrical control according to GAMP5 requirements 6: Connection to fluidized bed processor...

...Sabre escape equipment provides a 15 minutes constant air flow (starting with activation) according to the latest European norm. This is enough to leave incident in emergency. Technical data: The 10-minute version contains one 2L/200 bar compressed air bottle, 15- minute version contains 3L/200 bar compressed air bottle. The breathing air bottles have 400 or 600 litres free air capacity with an...

... design, degree of protec-tion IP 69K Media temperature -40…100 °C Wetted parts stainless steel EAC declaration (upon request) Approvals/Certificates - Explosion protection for gases and dust - Certificate of measuring equipment for Russian Federation - Material certificate as per EN 10204-3.1 - Calibration certificate as per EN 10204-3.1 - Classification per SIL2 Pressure...

...Laboratory gas meters in wet and dry designs are precision measuring devices with circular scale displays and resettable roller counters. The wet design can be supplied in seven load levels and in special versions for aggressive media or operating pressures up to 100 bar. All laboratory gas meters can be equipped with pulse transmitters upon request. To accurately prepare a quote based on your individual specifications, please contact our system technology department.