airtight components Germany

... influences from both inside and outside to prevent damage. With the correct system selection and application, the professional can ensure that - the interior side forms an airtight layer, - the exterior side provides a water-repellent barrier and also has wind-tight properties, - moisture from the construction can be adequately transported away through the breathable properties of the outer, and possibly the inner layer, - additional requirements such as temporary coverings are possible.

...Zipperbags are almost airtight, frequently reusable and withstand heavy loads. Therefore, zipperbags are ideal for long term use. Our pressure lock bags or zipperbags are easy to open and to re-close and protect the content from contamination or loss. They are suitable for packing all sort of goods, e.g. small components for technical or household devices, as well as foodstuff or...

...Shut-off dampers are used to block or close air flows. These shut-off dampers are employed for the isolation of air streams. They are designed to close airtight according to DIN 1946-Part 4. Additionally, the wear-resistant shaft bearing is also designed to be airtight. The shut-off dampers TYPE AK-E-LD (rectangular) are available in rectangular or square designs in sizes ranging from 100 x 100...

... screw channels can be easily covered after assembly with unobtrusive aesthetic clips. Useful lid stops are available to relieve the strain on internal components. To ensure that outdoor installation is almost always possible, the technoPLUS accessory series also includes a practical truss support that adapts to virtually any curvature. Inside, there are mounting domes for easy installation of internal components. ASA LURAN: Plastics...

...With the a-value measurement system developed by BlowerDoor GmbH, joint permeabilities in building components can be easily and accurately determined. For the realization of an airtight building envelope, the tightness of externally located windows and doors is also an important criterion. The DIN 4108-2 (2013) defines requirements for the tightness of externally located windows, window doors, and roof windows. Depending on the number of full stories of the building, joint permeabilities are classified into "classes" according to DIN EN 12207-1:2000-06.

...The metallurgical industry uses EXCOR ABRIGO paper especially for packaging inconsistent mold components. Due to its good stretchability, the creped paper adapts to the component without tearing. The wrinkled structure also provides cushioning properties. To achieve an external airtight barrier, VCI creped papers can be coated with polyethylene. The wrinkles in the paper increase its stretch and...