EUROGUARN DI BETTIO ANDREA

Each expansion joint is tailor made. Layers of material are assembled on a frame which conforms exactly to the required profile. Bellows type expansion joints incl. or without reinforcing rings/frames. Diaphragms Expansion joints for varying cross sections and transitions. Construction from round to rectangular Construction according to drawings Non-standard high temperature seals Compound movement

The number of patents awarded to KOREMA® such as SIMIFLON® reflects an ongoing commitment to long term development of specialty materials which have opened new horizons and perspectives for the future. SIMIFLON®, (light colored material) is designated foodstuff quality and certified according to § 177.2600/177.1550 CFR of US Food and Drug Administration (FDA) as well as to EU Regulations EU 2002/72/EG and EU 10/2011.

Profile guide rails can be screwed on from above. The profile guide rails are available in four sizes and one or more carriages can be assembled on them. 4row versions with round arch profile. The tracks of the profile guide rails are set below an angle of 45° and thus can carry loads from all directions. The profile guide rails correspond to the market standard and can replace linear guides of the same design by other manufacturers. On request Lengths up to a max. 3960 mm.

This is the most installed version of the fabric expansion joints (KOREMA® type A3 or AC3 as well as B3 or BC3). The name »flange-type« is used for expansion joints located between pipe or duct end flanges. For existing plants, the flange design varies according to customers’ requirements or depending on the constructed steel design. For innovative designs KOREMA® will identify the suitable technical and economical solution. Special design: supplied as »open« multilayer expansion joint. On-site service available exclusively from the KOREMA® service team. Insulation is incorporated to protect the expansion joint against abrasion as well as for thermal insulation. The choice of insulating material, either mineral wool or ceramic felt, depends on the design temperature. For operation at or below dew point, a vulcanized elastomeric layer is available. Pre-assembled units, complete with liners and clamp bars, are available.