BEC BETON EXPERTEN CENTER GMBH

COMPOSITION AND APPEARANCE Plaster-based powder filler, special cements, calcium carbonate, resin, cellulose fibre and various admixtures. The compound obtained is white in colour. TECHNICAL CHARACTERISTICS • Setting time : 30 to 40 minutes • Hardening time : 1 to 2 hours. • Second coating : after 3 hours • Adherence : complies with NFT 30 608 SUITABLE SURFACES All types of interior surfaces complies with DTU 59.1 : plaster, plasterboard, plaster blocks, concrete, cement coating, breeze blocks, cellular concrete, bricks, ceramic, old paintwork, old painted fibreglass, floor tiles, wall tiles, etc. COVERINGS After the filler has completely dried, it can be covered using all types of paints, plaster-based coatings, paste coatings, wallpaper paste. PREPARATION OF SURFACES Surfaces must comply with standard DTU 59.1 and be clean, dry and free from dust and any trace of separating agent. Correctly open up, bevel and dust off the cracks.

USES AND APPLICATIONS Small cementations, underground rafts and filling. General rehabilitations. COMPOSITION Crushed limestone aggregates of adjusted/correct granulometry (6/12mm and 0/5 mm) Portland Cement CEM 142.5R Additives APPLICATION METHOD Add 2.5 liters of water for each bag of concrete to obtain a soft consistency that will generate the indicated compressive strength. Knead well by hand or mechanically. Do not use at temperatures above 35° C or below 5° C.

Dry cement mortar made with aggregates and additives that give it optimum workability and adhesion, for the construction of walls, partitions in masonry or stone, the creation of coatings, joints and masonry work in general. For interior and exterior use.

Cement whitewashing, replastering, whitewash/rendering, masonry-brick walls, masonry/rubble walls, walls/ chicane/partition, roofing, vaults. COMPOSITION Conglomerates: Portland cements CEM I 42.5 R or BL-II42.5R Crushed aggregates with maximum dimensions of 2 mm (minerals of calcareous nature). Additives: fluidifier - plasticizer. METHOD OF APPLICATION Add 3.5 liters of water for each bag of porter. Knead well until obtaining a homogeneous paste. Place the mass on a clean support and spread it with force. At high temperatures, insolation or very absorbent supports, moisten beforehand. Do not use at temperatures above 35° C or below 5° C.