Results for
GREENWOOD-POWER
Austria
The LxxxR-21 current sensor is a completely new development from GWP, which enables the advantages of sensor technology also for the low voltage area. The design is fitting in existing common housings of CT´s, but with wide range behaviour and lower costs.
Request for a quoteGREENWOOD-POWER
Austria
The voltage sensors of Type TxxxB-xx is dedicated to the new T-connector of Euromold/Nexans, called (K) (M)480TB. The T-connectors are usually closed with a dedicated blind plug of a T-connector manufacturer, this could be removed and the sensor could be installed into this place. The sensor is than connected with the common earth and with the secondary connection cable to an IED.
Request for a quoteGREENWOOD-POWER
Austria
The NxxxE-0U current sensor is dedicated for installation on the cables of a gas or insulated switchgear in the primary or secondary energy distribution. The design is split able, which makes it able to put the sensor on an existing cable. Due to cost effective construction, the sensor has a very high cost-benefit ratio
Request for a quoteGREENWOOD-POWER
Austria
The NxxxT-0U current sensor is dedicated for installation on the cables of a gas or insulated switchgear in the primary or secondary energy distribution. The design is split able, which makes it able to put the sensor on an existing cable. Due to cost effective construction, the sensor has a very high cost-benefit ratio.
Request for a quoteGREENWOOD-POWER
Austria
The NxxxE-xx current sensor is dedicated for installation on the cables of a gas or insulated switchgear in the primary or secondary energy distribution. The design is split able and divided into 3 separate rings, which makes it able to put the sensor on an existing cable. The rings makes it possible to install this product inside switchgears, where the pole distance of the phases can vary up to 1.5m.
Request for a quoteGREENWOOD-POWER
Austria
The NxxxT-xx current sensor is dedicated for installation on the cables of a gas or insulated switchgear in the primary or secondary energy distribution. The design is split able, which makes it able to put the sensor on an existing cable. Earthing could be done at the current sensor, or through the shielding of the cable or through the S2 connection inside the IED.
Request for a quoteGREENWOOD-POWER
Austria
The NxxxR-xx current sensor is dedicated for installation on the bushing of a gas insulated switchgear in the secondary energy distribution. The design is slim and the holding system can be adapted to different kind of T-connectors. Earthing could be done at the current sensor, or through the shielding of the cable or through the S2 connection inside the IED.
Request for a quoteGREENWOOD-POWER
Austria
The A240P-5K voltage detector is a voltage sensor based on a capacitive divider principle. Inside the product there is a high stable capacitor, with a high capacitance and up to 15nF and up to 24kV insulation level. The product is dedicated for gas insulated switchgears and is used for asymmetric T-connectors from a range of different manufacturers.
Request for a quoteGREENWOOD-POWER
Austria
The A240S-5K voltage detector is a voltage sensor based on a capacitive divider principle. Inside the product there is a high stable capacitor, with a high capacitance and up to 15nF and up to 24kV insulation level. The product is dedicated for air insulated switchgears and could be used also as support insulators with bending forces.
Request for a quoteGREENWOOD-POWER
Austria
The voltage sensors of Type TxxxC-xx are commonly used in asymmetric T-connectors of different manufacturers. The T-connectors are usually closed with a dedicated blind plug of a T-connector manufacturer, this could be removed, and the sensor could be installed into this place. The sensor is than connected with the common earth and with the secondary connection cable to an IED. The product range -0U is especially made with maximum cost effectiveness by utilizing correction factors
Request for a quoteGREENWOOD-POWER
Austria
The temperature sensor system is made for solving a big problem in switchgears. It is modular and can be used in cable compartments of gas insulated switchgears or even in air insulated switchgears, directly on the medium voltage busbars to monitor temperature rises, especially in busbar conjunction points. The system could be delivered with wired cost efficient solutions for low voltage applications or on medium voltage cables or completely galvanic separated with a Power over fiber connection from the base station to the temperature sensors directly attached to the primary busbar.
Request for a quoteGREENWOOD-POWER
Austria
The voltage sensors of Type TxxxC-0U are commonly used in T-connectors of different manufacturers. The Tconnectors ar usually closed with a Type C - Blindplug, this could be removed and the sensor could be installed into this place. The sensor is than connected with the common earth and with the secondary connection cable to an IED. The product range -0U is especially made with maximum cost effectiveness by utilizing correction factors.
Request for a quoteGREENWOOD-POWER
Austria
The voltage sensors of Type T360Cxx is made for T-connectors with a Type C cone acc. IEC 50181. The Tconnectors are usually closed with a dedicated blind plug of a T-connector manufacturer, this could be removed, and the sensor could be installed into this place. The sensor is than connected with the common earth and with the secondary connection cable to an IED. This sensor is especially made for a insulation level of 36kV.
Request for a quoteGREENWOOD-POWER
Austria
The A240F-16K is a high voltage coupling capacitance dedicated for Power-line-carrier communication. It is used in outdoor applications, usually on poles. Inside of the product is a big capacitance of over 10nF, which makes the communication through the network possible.
Request for a quoteGREENWOOD-POWER
Austria
The K240A-xx is one of the newest developments from GWP. It is a combined voltage and current sensor in block type form factor dedicated for air insulated switchgears in the primary energy distribution. It contains a wide range current sensor and a voltage sensor, and it is even possible to put a 3rd component, a low power conventional current transformer inside to enable the maximum flexibility for the customer.
Request for a quoteGREENWOOD-POWER
Austria
The K120A-xx is one of the newest developments from GWP. It is a combined voltage and current sensor in block type form factor dedicated for air insulated switchgears in the primary energy distribution. It contains a wide range current sensor and a voltage sensor, and it is even possible to put a 3rd component, a low power conventional current transformer inside to enable the maximum flexibility for the customer
Request for a quoteGREENWOOD-POWER
Austria
The combined voltage and current sensors of Type K240F-xx are used in outdoor installations usually on poles. The sensor is connected with the common earth by the installation point of the product and with the secondary connection cable connected to an IED. It can resist all weather conditions and environmental changes due to the usage of silicon material, which is also used as standard materials for high voltage insulators.
Request for a quoteDo you sell or make similar products?
Sign up to europages and have your products listed
GREENWOOD-POWER
Austria
One of the latest developments of GWP is the ultra-wide range current sensor for the primary energy distribution. This product has an incomparable measurement range starting from 0,5A up to 100.000A with a defined accuracy. Primary use case is in combination with protection relays.
Request for a quoteGREENWOOD-POWER
Austria
The LxxxT-28 current sensor is a completely new development from GWP, which enables the advantages of sensor technology also for the low voltage area. The design is made for installation on low voltage cables either isolated or not isolated. It combines a wide range behaviour with low costs. The usage of correction factors enables even better corrections in combination with dedicated devices.
Request for a quoteGREENWOOD-POWER
Austria
The LxxxR-32 current sensor is a completely new development from GWP, which enables the advantages of sensor technology also for the low voltage area. The design is fitting in existing common housings of CT´s, but with wide range behaviour and lower costs.
Request for a quoteGREENWOOD-POWER
Austria
The LxxxT-44 current sensor is a completely new development from GWP, which enables the advantages of sensor technology also for the low voltage area. The design is made for installation on low voltage cables either isolated or not isolated. It combines a wide range behaviour with low costs. The usage of correction factors enables even better corrections in combination with dedicated devices.
Request for a quoteINTER CONTINENTAL BATTERY
Belgium
Maintenance-free batteries which reduces the maintenance costs. - Provides exact solution for acid leaking problem, it can still operate even it is partially broken. - Gives perfect result under the vibrant conditions - It can be returned back from deep cycle status even it is not immediately charged - Low internal resistance - Produced with a design protecting the positive plates, for prolonging the life cycle. - Environment friendly; it allows the alternative energy sources to be stored for reuse. - ‘GEL ENERGY’; gel formula has the effect of decreasing the heat on plates. It cause neither heating nor lose power in the case of excessive discharge. Fields of Application - Industrial Vehicles - In solar power systems - As marine battery in boats, yachts and sea transportation vehicles - In wind power systems - In defense industry such as military tanks, panzers and sea boats - In ambulances - In disabled cars - In construction equipment - In inter-cit
Request for a quoteResults for
Alternative energy sources - Import exportNumber of results
23 ProductsCountries
Company type