Design supply - Import export

Our designs are supported by Finite Element Analysis and mathematical design calculations. They are also done to international standards, such as ASME B31.1, B31.3, B31.4, B31.8, ASME B&PV Code Section I, Section III, Section VIII Division 1 and Division 2, PED, RCCM, EN 13480 and EN 10253. Other aspects such as corrosion tolerance, fatigue and piggability can also be assessed and analysed.

The need to begin studies in the field of injection anchors is testified by the stronger and stronger request by the designers for instruments and guidelines for the design of anchors and their application in the strengthening of masonry structures. One of the main aims of research is just that of supplying design recommendations which may be of help for designers and technicians working in this field. Laboratory tests In collaboration with the Civil Engineering Department (DICATA) of the University of Brescia a set of laboratory tests were carried on masonry samples in order to check the capacity of the injection anchors with sock in terms of adherence and mechanical interlocking with the substrate. The execution, during the research activity, of a great number of tests has lead to the definition of parameters that are fundamental for the design of injected anchors with sock, as the bond strength at the steel barinjected grout interface an at the injected groutsubstrate interface.

AIC manufactures and supply PLC platforms, AC&DC drives panels suited to allow an enhanced power control of each equipment using all the drives available on the market, such as Rockwell Automation, ABB, Siemens, Nidec, Schneider, according to the customer needs/requirement. The power control supply includes: - AC Medium voltage panels suited with dedicated power transformers, up to 7MW; - Low voltage AC Drives: Single motor drives, Multidrives with DC Bus supplier; - Low voltage DC Drives; - Soft-starter for smooth acceleration; - MCC for fixed speed drive design; - AC & DC motor and gear motor basic & detailed design and supply.

Designed for the supply of medium size aggregates, ALV screening feeders make it possible to separate the fine from the coarse fraction. These machines are generally used for the feeding of primary or secondary crushers. The vibration is generated by adjustable eccentric mass electric moto-vibrators . Made in different sizes depending on the particle sizes and flow rates to be obtained.

FIP INDUSTRIALE supplies and designs different types of inserts that can be fitted on every type of segment: Threaded inserts permit easy handling of bridge segments during erection; Inserts for injection facilitate injection of mortars or similar products at extrados level. Our range of products also includes combined inserts; Grounding inserts ensure the creation of an electric bridge, if required. Other types of special inserts have been designed and supplied in the past subject to prior specific examination. A type of combined insert.

They include a broad range of connection systems for bridge segments, gaskets, guidance rods, adhesives, packers, lifting-injection and grounding systems. FIP INDUSTRIALE can design, develop, test and supply any accessory for bridge segments, in every case in which tunnels are mechanically excavated by means of TBM mills which results in the use of prefabricated bridge segments. It can also supply flat jacks, bentonite or vulcanized rubber hydroexpansive gaskets for any type of tunnels and other structures which do not imply TBM mills TYPES: Watertight gaskets Adhesives Load spreading pads Inserts Biblock systems and bolts Guidance rods Flat jacks Hydroexpansive gaskets