Results for
ENNOX BIOGAS TECHNOLOGY GMBH
Austria
Condensation from saturated biogas collects at the lowest points in the pipework, in bends etc. This can negatively influence the effective operation of biogas systems. ennox condensate accumulator is installed at the lowest point in the pipework. The condensate gathers in the container where it can be discharged through a manual tap and/or an automatic siphon. As an option ennox will supply a level indicator or an automatic discharger.
ENNOX BIOGAS TECHNOLOGY GMBH
Austria
Gas from bio or sewage processing systems are often contaminated with water vapour or very sparsely distributed small particulate matter, which, when used for example in CHP units can cause operating problems or even damage. For the fine cleaning of the gases before utilization an ennox ceramic fine filter is used. In the ennox ceramic fine filter the fine particles contained in the gas are captured by a special fire-clay filter (Pantel). Condensate collects in the form of a moisture layer on the surface of the material and drips into the collector below. An automatic discharge system with level indication can be installed in the base of the digester upon request.
MEDEK & SCHÖRNER GMBH
Austria
Special high speed adapted ink jet printer with finely adjustable printhead support for marking bandmarks from one side on the fiber at speeds up to 1150 m/min. The usual arrangement allows bandmarking in line with the ink coating process, providing irradiator units after the ink jet printhead and the ink applicator. In case that no additional UV lamp unit and only the UV lamp of the UV curing unit CCD1-K unit is available, bandmarking has to be done in a separate process (either bandmarking or ink coating). The microprogram of the ink jet printer is specially adapted for ultra high speed bandmarking with automatic control of a constant bandwidth over the full speed range. Bandmark pitch and interband distance for multiple bandmarks (double, triple, etc.) are easily programmable on the computer screen. LD - INK LEVEL SENSOR AND INDICATOR SYSTEM FOR INK TANKS Triggers a warning signal as the ink level drops below minimum.
Request for a quoteMEDEK & SCHÖRNER GMBH
Austria
Automatic synchronization to the line over a 1:6 speed range (requires a 0 V to 10 V signal proportional to the line speed); for lines providing no such control signal a dedicated frequency generator with tachometer wheel and incremental encoder is required. V - AUTOMATIC VISCOSITY CONTROL FOR PRINTING INKS An oscillating sensor causes thinner to be added when the viscosity deviates from a preset value. LD - INK LEVEL SENSOR AND INDICATOR SYSTEM Triggers a warning signal as the ink level drops below minimum. FW - INK FLOW SENSOR AND INDICATOR SYSTEM Triggers a warning signal as the ink flow deviates by an adjustable amount from the preset value. MARKING DRUMS Easily replaceable pairs of marking drums for use as spares for supplied marking drums or for changing the ring spacing or pattern. Standard ring patterns include single or double rings every 17 mm; double rings every 34 mm; one, two, three, or four rings every 60 mm
Request for a quoteDo you sell or make similar products?
Sign up to europages and have your products listed
Results for
Level indicators - Import exportNumber of results
4 ProductsCompany type