Steel C35Pb. Gunmetal Rg7. Plastic PA6.6 with MoS2). ISO trapezoidal thread based on DIN 103. Steel nuts for adjustments during manual operation and as fastening nuts. Not advised for use with motorised drives due to the steelsteel material combination. Gunmetal nuts for motion drives with low and medium speed. By insufficient lubrication, gunmetal trapezoidal thread nuts on steel spindles have good dryrunning properties. Plastic nuts for lownoise motion drives. Good dryrunning properties. Tolerance class 7H.
NORELEM FRANCE
France
Steel 1.0401 (C15) or stainless steel 1.4301 (whirled spindles stainless steel 1.4305). Version Steel rolled, bright. Stainless steel up to Tr 40x7 rolled, above this whirled, bright. Note Rolled, high precision trapezoidal thread spindles. ISO trapezoidal thread based on DIN 103. The trapezoidal thread spindle is a transmission thread with relatively high friction. Standard thread forms are selflocking. This has the advantage that they generally do not need to be secured in the rest position. Tolerance class 7e Pitch precision 0.3/300 mm Length sawed with excess, ends not deburred.
Request for a quoteNORELEM FRANCE
France
When screwing the nuts onto the thread, the thread lock is plastically and elastically deformed. The elastic deformation causes a radial frictional lock against the nuts being loosened. The plastic thread lock is only effective when the nuts are fully screwed onto the male thread. The screw length must be selected so that at least two full threads protrude from the nut. Due to the plastic deformation of the thread lock, these nuts should only be used once.
Request for a quoteNORELEM FRANCE
France
Universal joints with plain bearing can be swivelled by 45°. Max. transferable torque (Nm) at 150 rpm, operation angle α < 5°. * Bore depth is less than by DIN 808.
Request for a quoteNORELEM FRANCE
France
Keyless locking coupling with low mass and moment of inertia. Easy to connect and release – no jamming on the shaft. Perfect for zero backlash connections. Excellent concentricity and running. Suitable for keyed and keyless shafts. for shaft diameters from 5 to 35 mm for high torques minimum axial offset when mounting selfcentring Assembly Shaft and hub must be free of oil, grease and dirt. Do not lubricate keyless locking coupling. Insert keyless locking coupling in the hub seat and slide onto shaft. Tighten nut by hand and use a torque wrench to tighten to the defined tightening torque. Tolerances Shaft diameter and hub hole Form A ±0.04 mm. Form B ±0.08 mm. Surface quality Rz ≤ 16 µm.
Request for a quote