SFP Subsea Wire Rope Flange Pulling System

700 BAR (10,000 PSI) Maximum Working Pressure Allows connection of up to 4 tools Stainless steel construction (rust free) Internal relief valve controls retracts pressure Couplers on reel side are flat face for easy connection under water. Couplers on valve side match the required tool. Dimensions (WxLxH): 420 x 270 x 200 (mm); 16.5 x 10.6 x 7.9 (in.) Weight: 9 kg (19.8 lb)

Designed for high performance and reliability, our Subsea Pulling System provides the following benefits: Compact design Long Piston Stroke - 4" (102mm) 10,000 psi (700 bar) systems Rapid assembly using Quick Release Reaction Nuts High strength threaded bar Anti-Slip surfaces Operated via separate diver control valve providing precise control for up to 4 pullers Compact Design Designed to fit ANSI B16.5, MSS SP44, API 6A and most other flange applications dedicated flange hole adapters. Hydraulic Anchor Collet Release Anchor collet automatically grips wire rope (without hydraulic pressure). Collets can be fully released by applying hydraulic pressure. Auto Advance Collet Release Advance collet fully disengages when the pulling cylinder is fully retracted Manual Retract Collet Release Retract collet can be manually disengaged, allowing the pulling cylinder (including Advance and Retrace collets) to be removed from the wire rope while the rope is installed in the flanges. Also...

EHN TOP COLLAR HYDRAULIC NUT Our precision machined top collar hydraulic nuts offer a quick, accurate and cost effective solution to simultaneous tightening of multiple bolted joints. In addition to standard features normally associated with hydraulic nuts, our system also provides the following benefits: Compact enough to fit the most confined spaces Maximum load generated at 21,750 psi (1,500 bar) Energized from either a hand operated or air driven pump Custom Hydraulic Nut designs available Alternative Bottom Collar and Shim type versions available Made to order. Contact factory for availability.

HFS PIPE FLANGE SPREADER You’ll never again have to resort to “hammer and chisel” methods that waste time and effort. Flange spreaders should be used in pairs to provide even spreading force. Standard 60° wedge is suitable for most flanges; 30°“thin” and 60° “blunt” wedges are optional. The HFS3A is designed for applications where total thickness of flanges and maximum Spread gap is 3"(76,2 mm) or less and flange bolts are a minimum of 11/16" (17,5 mm) diameter Use HFS6A if total thickness of flanges and maximum Spread gap is 6" (152,4 mm) or less, and flange bolts area minimum. of 13/16" (20,7 mm) diameter.