Series RH600 Twist-Lok™ Pins replace costly screw machined pins and eliminate problematic installation of screws and rivets. The helical knurl minimises stress during installation by rotating as it engages the hinge. Corrosion-resistant material and a rounded burr-free head improve installed appearance. Axial and radial forces induced in the hinge eliminate the tendency for the pin to creep and maintain hinge tension.
SPIROL
Germany
SPIROL's FH400 Headed Barbed Pin has a series of barbs extending down the entire length of the pin. Headed Barbed Pins are a great replacement for self-tapping screws in plastic assemblies as Barbed Pins are installed into standard moulded (or drilled) holes, they install much faster than screws, and they eliminate issues associated with cross-threaded or skewing during installation. Unlike screws that resist back-out (or loosening) by being tightened to a preset torque, Barbed Pins are retained by the plastic backfilling over the aggressively-designed barbs. The head provides a positive stop and is also used to retain a thin component to a thicker component within an assembly. SPIROL's FH400 Headed Barbed Pins are available in metric diameters ranging from Ø2mm to Ø6mm and inch diameters ranging from Ø.078" (5/64) to Ø.250" (1/4) in low carbon steel and austenitic stainless steel.
Request for a quoteSPIROL
Germany
SPIROL designs and manufactures specific types of Solid Pins to meet the performance and assembly requirements of common niche applications. These Solid Pins are variations of our standard product either manufactured from specific material, have a specific finish or undergo specific processing to meet performance, corrosion, compatibility and assembly requirements for the specific application. These pre-designed application-specific series of Solid Pins help companies shorten the design cycle to confidently launch their product quickly to the market with a pinning solution that has been tested and proven within their assembly.
Request for a quoteSPIROL
Germany
SPIROL's BP100 Press-N-Lok™ Pin has opposing barbs on each end of the pin and is designed to permanently retain two plastic components to each other such as two halves of a plastic enclosure. Press-N-Lok™ Pins are installed in two stages: First, press the pins into one half of the plastic housing. Next, align the other half of the housing with the exposed pins and press into place. During installation, the plastic will backfill into the area around the barbs resulting in maximum resistance to axial force. SPIROL's Press-N-Lok™ Pins are manufactured from lightweight, lead free aluminium as a standard, and available to order in austenitic stainless steel. BP100 Press-N-Lok™ Pins are available in diameters ranging from 2mm to 4mm.
Request for a quoteSPIROL
Germany
SPIROL's Barbed Pins were created specifically for use in flexible plastics where optimum resistance to axial force is desired. The raised barbs are angled backwards, opposite the direction of insertion. After installation, the plastic will backfill into the area around the barbs resulting in maximum retention. Barbed Pins are ideal for applications requiring high pull-out (tensile) strength, and to prevent disassembly (i.e. tamperproof ). Barbs are not appropriate for brittle plastics or those containing high percentages of fillers. As barbs are a radial feature, they do not resist rotation of two components relative to one another. For this requirement, a straight or helical knurl should be used. All Barbed Pins are provided with a generous pilot to facilitate alignment with the hole and ease installation.
Request for a quote