Due to many years of experience in the field of damping technology, LEBEN is able to replace shock absorbers of other makes from various manufacturers. The required characteristics of the damping property as well as the dimensions of these industrial shock absorbers to be replaced can usually be met by a replacement shock absorber made by LEBENDämpfungstechnik GmbH.
France
Industrial shock absorbers are maintenance-free, ready to install hydraulic components. They have an integrated fixed stop. The adjustable version enables precise adjustment to the desired dampening level. After installation, operate and adjust the shock absorber a few times until the desired braking level is achieved. Exceeding the max. energy intake per hour is possible if temporarily disconnected or the shock absorber is cooled with cylinder exhaust air. The installation position is arbitrary.
Request for a quoteGermany
High Rack Damper, Optimized Characteristic Energy capacity 14,500 Nm/cycle Stroke 100 mm Intelligent protective measure: The safety shock absorbers from the SDH38 to SDH63 series are also designed for emergency-stop applications. Strokes of up to 1,200 mm are possible with these maintenance-free and ready-to-install dampers. Low support forces result due to the large strokes. The characteristic curve or damping characteristics of all safety shock absorbers from ACE is individually adjusted to the respective application, specific to the customer. The metering ori?ces for the respective application are specially calculated and produced. These tailor-made machine elements are the ideal protection because they are less expensive than industrial shock absorbers and are effective with up to 1,000 maximum full load emergency cycles possible.
Request for a quoteRomania
SBS suspensions are made of thermoplastic rubber, characterized by increased elasticity, as you can see in the videos below. It helps to mitigate the impact by cushioning when the bed frame is subjected to weight. It is mounted on their struts by being fixed on the bolts (click here) by pressing. The ideal supports for slats with a width of 38 mm are available in several colors and sizes, their role being to ensure increased comfort. The narrowest ones of 3.5 cm are used on the central spar of the bed frame, being fixed on both sides of it, while the medium supports of 5 cm and the widest ones of 6.5 cm are mounted on the outer spars.
Request for a quoteGermany
With threephase servo drive sized according to job requirements Machine body in sturdy clean steel plate design Rollers made of highquality 63 RW tool steel, hardened and polished Pneumatic pilot release with parallel lift of upper roller, guided on gear rack Entry catenary rolls Manual edge guides Simple programming of even complex feeding cycles, Display in cleartext Manual functions for setup such as creep speed, jog mode, single feedtolength Simple memory and recall of job programs for quick changeover Mounting bracket with height adjustment via spindle or hydraulic handpump (optional motorized) Hard chromed or polyurethane coated rollers (optional with Topochrome coating for highgrip feeding) Measuring wheel system for highest feeding accuracy Stroke limitation for faster piloting Fine adjustment of upper roller and strip guiding device for thin stocks (starting at 0,1 mm thickness) Central edgeguides with hand wheel
Request for a quoteCreate one request and get multiple quotes form verified suppliers.