Grease lubrication of plain and rolling bearings at high temperatures and high loads, e.g. on hot-air fans, converters, pouring ladles, sintering systems, conveyor systems subject to heat etc. Advantages and benefits Excellently suited for reducing friction and wear, protection against corrosion and impurities Maintenance of lubricating effect even at high temperatures and loads Highly effective due to selected combination of active ingredients for good corrosion protection properties, good resistance to ageing and excellent EP properties
OKS SPEZIALSCHMIERSTOFFE GMBH
Germany
Lubrication of chains, joints and slideways at high temperatures Conveying systems in painting, stoving and drying systems Food-processing machines Advantages and benefits Can be used up to 250°C NSF H1 registered, conforms to the requirements of the Hazard Analysis Critical Control Points (HACCP) method in the food processing industry Good adhesion on metal surfaces Excellent water resistance Excellent oxidation properties Excellent wear protection MOSH/MOAH-free
Request for a quoteOKS SPEZIALSCHMIERSTOFFE GMBH
Germany
Lubrication of friction, rolling and pivoting bearings, splined shafts, knockout spindles and sliding surfaces of all kinds under normal loads and all sliding speeds common for grease lubrication Supports sealing of bearings and corrosion protection Advantages and benefits Highly effective due to optimum combination of components Good resistance to pressure and water Fewer downtimes and repairs as a result of reduced wearing Resistant to ageing and oxidationFor highest effectiveness, carefully clean the lubrication point, for example with OKS 2610/OKS 2611 universal cleaner. Before filling for first time, remove anti-corrosion agent. Fill the bearing such that all functional surfaces are certain of being greased. Fill normal bearings up to about 1/3 of the free space inside the bearing. Low-speed bearings (DN value < 50,000) and their housings should be filled completely. The bearing and machine manufacturer's instructions should be observed.
Request for a quoteOKS SPEZIALSCHMIERSTOFFE GMBH
Germany
Lubrication of parts subject to high levels of stress such as plain, roller and rod-end bearings, spindles and guideways Advantages and benefits Highly suitable for high-stressed lubrication points Highly effective caused by optimal combination of components Saving of maintenance and lubrication costs by reducing downtimes and corrective maintenance Reduction of down times due to wearFor highest effectiveness, carefully clean the lubrication point, for example with OKS 2610 or OKS 2611 universal cleaner. Before filling for first time, remove anticorrosion agent. Fill bearing such that all functional surfaces are certain of being greased. Fill normal bearings up to about 1/3 of the free space inside the bearing. Low-speed bearings (DN value below 50 000) and their housings should be filled completely. The bearing and machine manufacturer´s instructions should be observed. Subsequent lubrication at the lubrication nipples by grease gun or by automatic lubrication system.
Request for a quoteOKS SPEZIALSCHMIERSTOFFE GMBH
Germany
For the long time- or for lifetime- lubrication of fast running roller and plain bearings as well as linear guides, threaded and ball screw spindles, small gears and similar components, exposed to high pressures and higher temperatures Advantages and benefits Good adhesive and good media resistant Good low-temperature behaviour, stress absorbing ability and smooth run at high speeds Good plastic compatibility The low start and running moment, especially at low temperatures, enables a high efficiency The good wear protection increases the life time of the part and makes sure a reliable functionFor best results clean the lubrication point with OKS 2610/OKS 2611 Universal Cleaner. Remove the corrosion protection media before initial filling. Fill the bearings in a way that all the functional surfaces are lubricated sufficiently. Slow moving bearings (DN-value < 50,000) should be filled completely. Fast running bearings (DN-value >400,000) should be filled
Request for a quote