NORELEM FRANCE - Leader mondial des composants standard destinés à la construction et à l’ingénierie mécanique

Lightweight aluminium profile for weightoptimised constructions.

Aluminium profile for general constructions.

Aluminium profile for general structures. The round tube, also referred to as a profile tube forms a feed roller when used in combination with bearing flanges (10400).

The aluminium profile is matched to the roller elements. As a result, roller rails and roller tracks can be realised. The different inserts permit modular and flexible setup.

Lightweight aluminium profile for weightoptimised constructions.

The aluminium profile is matched to the roller elements. As a result, roller rails and roller tracks can be realised. The different inserts permit modular and flexible setup.

The connecting sets are used for connecting two aluminium profiles at right angles. The connection is nonrotating. For larger profiles several connecting sets can be mounted on the end for greater strength Low workload. Cut a thread in the end face core hole. Drill a through hole for tightening the screw in the opposing profile.

The connecting sets are used to connect two aluminium profiles at right angles. They allow free position of the profiles. The profile slots positioned at rightangles to each other remain free. Panel elements can be positioned in the profile slots without additional machining. Due to the reduced clamping force and omitted rotation locks, these connecting sets should only be used in combination with panel elements and lightly loaded constructions. Low workload. To assemble a hole must be drilled into one of the profiles. The D2 hole can also be drilled through.

Angle diecast zinc. Screws and slot nuts steel. End cap polyamide, fibreglass reinforced. Version Angle painted aluminium tone. Screws and slot nuts electro zincplated. End cap black. Note Suitable for reinforcing profile constructions and for frictional connection of profiles with each other without machining. Can also be used as fastening element (e.g. bracket) for any components. The angles have centring lugs for accurate and twistproof mounting. The centring lugs can be removed if necessary by breaking off i.e. for mounting plates. The open side can be closed off with the end cap.

Clamping angle diecast zinc. Grip diecast zinc DIN EN 12844. Steel parts stainless steel 1.4305. Cam lever cast aluminium. Body steel. Version Clamping angle painted aluminium tone. Handle powdercoated. Stainless steel bright. Slot key electro zincplated. Cam lever black powdercoated, steel parts black oxidised. Note The clamping angles are used for connecting two profiles of the same series that have contact on the side faces and cross at any angle. Loosening the screw releases both clamps allowing free rotation and sliding along the slots. The clamping angles are generally used in pairs or in combination with a joint angle.