Permanent magnet transporters are used where switchable lifting magnets cannot be used due to insufficient material thickness. They are suitable for thin sheets from 2 mm and are less expensive than lifting magnets, but must be separated from the workpiece under tension by means of a forcing-off device. They are suitable for use in sheet metal storage, on flame or laser cutting equipment, on shears or punching machines, and in steel and container construction. Magnetic transporters of types SH and MK are not compatible with the latest European standard for lifting magnets. We recommend their use only in protected areas.
FLAIG MAGNETSYSTEME GMBH & CO.KG
Germany
FXE-MH electro-permanent lifting magnets are especially suitable for transporting slabs and blocks. The electro-permanent modules type MH are designed to safely lift large loads with a large air gap. Electro-Permanent Lifting Magnets FXE Electro-Permanent Lifting Magnets from Flaig Magnetsysteme have been setting standards for over 20 years Electro-Permanent Lifting Magnets are the best choice if: the load to be moved is too large for permanent magnets the lifting magnet must be operated and controlled ergonomically the geometry of the load does not fit permanent magnets the lifting magnet must be remote controlled and possibly load adjustable the load capacity is too large in relation to the material thickness for permanent magnets
Request for a quoteFLAIG MAGNETSYSTEME GMBH & CO.KG
Germany
Plate-spreading-magnets are used for separating of stacked iron and steel sheets. The sheet separators are laterally grown from the sheet stack, they magnetize the sheets with the same poles, which repel them from each other. Plate-spreading-magnets apply both in automated systems where plates with vacuum or transshipped are magnetic, and the manual work, where the gripping sheet is greatly facilitated by their help. Our Plate-spreading-magnets consist of a reinforced magnet system, which is installed in a stable sheet steel housing.
Request for a quoteFLAIG MAGNETSYSTEME GMBH & CO.KG
Germany
The FX-HV Horizontal-Vertical System will meet with its diverse setting almost any need. Overall height and focus can be adjusted by plug pins. Likewise, the device also can be used for up to 20% of its rated load without engaging under pads.The support pins are positioned in a way so that standing blanks can be struck, which, for example, is often required on the saw. Likewise lying discs and sheets can be placed. For horizontal transport, the system has a lifting eye on the back. The steel structure is completely coated, and the stable FX Lifting magnet ensures maximum safety. Special dimensions are available on request.
Request for a quoteFLAIG MAGNETSYSTEME GMBH & CO.KG
Germany
FX-C lifting magnets have a round, multipole clamping surface, designed for lifting rings, sleeves, bearing housings, flange plates and similar workpieces.The load specification is valid for full-surface mounting on workpieces which cover D inside to D outside (see table Dimensions), for workpieces with a smaller mounting surface an approximate maximum workpiece weight of 3.5 kg per cm² clamping surface can be calculated. For serial workpieces, a documented test should confirm the safety factor 3.
Request for a quote