MACHINE Tap Form C, spiral flutes, 35°, For stainless steel, Metric

Thread standard: Metric, ISO DIN 13 Type: Machine tap Forma C, for blind holes, with spiral flutes Application: For high-tensile materials and stainless steel Material of product: HSSE PM Surface treatment: TiAlN For materials: High-tensile materials, Stainless steel, Alloyed heat-treatable steel, Cast iron, Aluminium cast and wrought alloys, etc* Tensile strength up to: 1400 N/mm2 Standard: DIN 371/376 Tolerance: ISO2/6H Special geometry, base material and surface treatment for Stainless steel. The TiAlN surface treatment increases the surface hardness (approx. 3300 HV), the sliding properties (friction coefficient: 0,25) and with high temperature resistance up to 800°C. It provides a better cutting performance and increased tool life time. The base material is powder metal (HSSE PM) with a higher hardness and toughness. The conical reduced leading thread improves chip drain and reduces thread friction. Tap for machine use in blind holes.

Thread standard: Metric, ISO DIN 13 Type: Hand tap, Form C, for through and blind holes, with straight flutes Application: For stainless steel Material of product: HSSE Surface treatment: VAP For materials: Stainless steel, Wear resistant steel, High alloyed steel Tensile strength up to: 1400 N/mm2 Standard: DIN 352 Tolerance: ISO2/6H The oxide surface (vaporized) improves the adhesion of the cutting oil and provides a stabil lubricant film. Cold welding in the tap flanks is reduced. Set of 3 taps (taper, intermediate, finish). Three-piece hand taps- sets are used for regular threads with coarse pitch, as the thread profile area is larger than for fine threads and the force effects on the taps are greater. The advantage of three-piece hand taps is that the respective parts of a set share the cutting power: The taper tap (No. 1) (marked with one ring) removes 65 per cent of the thread profile and the intermediate tap (No. 2) (marked with two rings) removes 85 per cent.

Thread standard: Metric, ISO DIN 13 Type: Round die Application: d25x9 Material of product: HSS Spiral entry: no For materials: Unalloyed and low alloyed steel, non abrasive material Tensile strength up to: 750 N/mm2 Standard: DIN 223 Tolerance: ISO-6g Round dies are cylindrical and are used for making external threads in one operation. They have - depending on the size - three or more cutting edges inside. The holes between the cutting edges receive the chips, roll them and discharge them. Dies are used to cut screws, nuts and threaded rods in everyday use. The die holder is used to cut the threads by hand and with the special die holders you can also attach the round die to a tailstock or to a drill. The dies can usually be used on both sides and have a perfect cut. Our taps and dies are produced to the highest quality standards, to ensure precise quality threads. Wide range of hand, machine and rolling taps, dies and tools for cutting professional threads on various materials

Thread standard: Metric, ISO DIN 13 Type: Round die Application: Undersized diameter Material of product: HSS Spiral entry: no For materials: Unalloyed and low alloyed steel, non abrasive material Tensile strength up to: 750 N/mm2 Standard: DIN 223 Tolerance: ISO-6e Round dies are cylindrical and are used for making external threads in one operation. They have - depending on the size - three or more cutting edges inside. The holes between the cutting edges receive the chips, roll them and discharge them. Dies are used to cut screws, nuts and threaded rods in everyday use. The die holder is used to cut the threads by hand and with the special die holders you can also attach the round die to a tailstock or to a drill. The dies can usually be used on both sides and have a perfect cut. Our taps and dies are produced to the highest quality standards, to ensure precise quality threads.