Hidromar Super-flex CM 02P

Self-levelling cement mortar modified with additives that give it the ability to be fluid and pumpable, especially for screeds and levelling of coatings with a thickness between 5 mm and 20 mm that, once hardened, must be covered with coatings. USES Applicable on concrete or cement mortar substrates, on low porosity substrates, apply previously a Fixmar Primer GR bonding primer. Regularisation of continuous screeds. Ideal in situations where a flat surface is required as a support for the subsequent application of another type of coating, such as parquet, carpet, ceramic tiles, linoleum, ceramic materials, marble... Suitable for underfloor heating and as a finishing material for synthetic coatings. Not suitable for wear surfaces.

Cement-based self-levelling mortar for low thicknesses 5-20 mm, type CT-C30-F7-A22, made with marble aggregates and special additives that give it optimum fluidity, to be used for the regularisation, repair and levelling of paving slabs. It is a product with high mechanical resistance and a good surface finish, ideal for the creation of continuous screeds. This mortar can be applied on a wide range of supports such as concrete, cement screeds, anhydrite, ceramic or natural stone, both indoors and outdoors.

Colored adhesive joint for sealing joints from 0 to 15 mm, with high resistance to abrasion and reduced water absorption. USES Seal joints between floor and wall tiles, both indoors and outdoors. Suitable for all types of ceramics and stones. Suitable for filling swimming pool joints.

Low-slip cementitious adhesive type C1T according to UNE-EN 12004:2017, designed with marble aggregates, cement and special additives that give it ideal adhesion, slip and water retention properties for laying ceramic tiles. USES For fixing tiles, medium/high porosity stoneware, in interior cladding, on traditional plaster supports. Prefabricated plasterboards and panels. Suitable for anhydrite substrates.