DPFR-001 Clamping force of a pressure

The SM71 series force sensors were specially developed for measuring clamping forces. The short measuring path of 0.019 - 0.14 mm (depending on the measuring range) and a natural frequency in the kHz range guarantee optimal results even for highly dynamic tasks. Typical applications include the simple determination of screw preloads, where the force sensor is used as a “measuring washer”. The very good reproducibility is less than one percent of the nominal load. The sensor is available in measuring ranges from 20 up to 2000 kN. Hardened washers are already included in the scope of delivery for quick and easy installation. The extremely simple and robust design is made entirely of stainless steel (protection class IP68).

Backlash-free angularly aligned transmission optimum compensation of misalignment very high torsion spring stiffness minimum restoring forces vibration damping ideal for measuring applications design with nickel bellows and screw hubs

Backlash-free angularly aligned transmission optimum compensation of misalignment very high torsion spring stiffness minimum restoring forces vibration damping ideal for measuring applications design with nickel bellows and clamping hubs​

Mobile test device for detection of the maximum torque (drag indicator mode) and for the detection of the power range (constant load) of motors in dental and dental surgical application area. arbitrary loading curves endurance test speed ​​measurement in aluminum case permanently installed Calibration disc and calibration will be in the trunk.