Capacitive sensor - use at temperatures from -40 C°…+200° C

EGE amplifier for Ex proximity switches complement the intrinsically safe EGE sensors. They are used for switching point adjustment and provide functional and output indications as well as the output signals. They also provide the 30 V DC or 127 V AC or 230 V AC power supply. The devices can be set up intuitively using a potentiometer and have a cable break and short circuit monitoring feature. The NC/NO contact output functions can be adjusted. The analysis devices are intended for top-hat rail assembly in a control cabinet in the non-explosive area.

Inductive proximity switches of this product family cope with the most difficult environmental influences found during offshore use. The proximity switches are based on the conventional inductive principle and switch when a metallic object moves close. Contactless positioning tasks in seawater environments or even below the sea level require special properties, such as a high IP class, high pressure and impact resistance and seawater resistance. These properties are achieved by, for example, using materials such as stainless steel 1.4571, longitudinally watertight and seawater-proof cables or even a one-piece stainless steel housing. Sensors of this series can be used at a water depth of up to 300 m.

EGE flow rate sensors for the flow rate detection of 10...100 l/min feature one-piece measuring tubes with an inner diameter of 20 mm from highly resistant stainless steel V4A (1.4571). For particularly aggressive media EGE offers special materials, such as bronze, Hastelloy, titanium or even PTFE. The devices can either be set up intuitively using a potentiometer and LED indications or easily programmed using buttons and a multi-segment display. EGE flow rate sensors can be installed in circuits with corresponding pipe diameters using threaded fittings or compression fittings. The provide excellent measuring results wherever the safe, robust and low-maintenance monitoring of low flows is required.

EGE flow sensors for gaseous media in explosive areas permit the space-saving flow measurement on site and the comfortable setting of the limit value using separate amplifier. The measurement takes place without mechanically moving parts using a thermal measuring element. The current flow state is displayed at the amplifier using LEDs. The devices are used wherever a safe, robust and low-maintenance monitoring of flow values is required. The measuring sensors of the product series ST 400 Ex; STS; STEX have ATEX approval and may, dependent on their design, be used in Gas-Ex areas requiring equipment for EPL Ga or EPL Ga/Gb. In the Dust-Ex area their use is permitted up to EPLDa.